909 SSP Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Електроінструмент 909 SSP. 909 SSP 11 сторінок. 65w multi purpose sharpener

Друкувати сторінку

3. Hold the knife handle and

slide the handle end of the

knife edge down the angled

face until it touches the

grinding wheel and draw the

knife towards you. Do not

apply too much pressure.

4. Insert the knife into the other

side of the guide and repeat 3.

5. Repeat sharpening each side

until a clean sharp edge

is achieved.

6. Switch the power unit OFF,

before removing the module.

Ensure the grinding wheel

has stopped.

Sharpening scissors

1. Slide the knife and scissor module (8) on to the power

unit, ensure it clips secure into place.

2. Switch the power unit ON, wait until the grinding wheel

is at full speed.

3. Open the scissors to be sharpened fully.

4. Keeping the pivot of the

scissors to the right hand side,

offer the blade to the face of

the grinding wheel resting the

blade on the angled rib.

5. Draw the blade across the

face of the grinding wheel from

pivot to tip. Use a slight but

steady pressure.

6. Turn the scissors over to sharpen the second blade,

keeping the pivot to the right hand side. Sharpen from

pivot to tip again.

7. Repeat 5 and 6 until a clean sharp edge is achieved.

8. Switch the power unit OFF, wait for grinding wheel to

stop before removing the module.

Sharpening high speed drill bits

Note.

Sharpens HSS drill bits from 3mm – 10mm.

1. Slide the high speed drill sharpening module (6) on the

power unit until it clips securely into place.

2. Remove the clamp (7) from the module and insert the drill

bit to be sharpened, tighten the clamp lightly so the drill

bit can still move freely.

3. Place the clamp containing

the drill bit into the depth

setting slot, using the grooves

to locate correctly.

4. Move the drill bit forward so

that it lays in the "V" guide and

touches the metal end stop.

5. Tighten the clamp so the drill

bit is secure.

6. Remove the clamp and drill bit from the setting position

and locate onto the sharpening position ribs, and push

down firmly.

7. Switch the power unit ON.