Autonics TZN4L Посібник - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник для Контролер Autonics TZN4L. Autonics TZN4L 17 сторінок. Dual pid control temperature controller
Також для Autonics TZN4L: Інструкція з експлуатації (2 сторінок), Посібник (16 сторінок), Посібник (17 сторінок)
Друкувати сторінку
TZN/TZ Series
Configuring Input Type
Please configure the internal switches before supplying power. After supplying power, configure the input type [IN-T] in
parameter group 2 according to the input type.
Input type
S/W 1
Thermocouple
RTD
Voltage
(0-10VDC,
1-5VDC)
Analog
Current
(DC4-20mA)
Unit Description
1
2
3
4
7
8
1. Present value (PV) display (red):
RUN mode: displays the current value (PV)
Setting mode: displays parameters
2. Set value (SV) display (green):
RUN mode: displays the set value (SV)
Setting mode: displays parameter setting values
3. SV2 operation indicator: turns ON when SV2 is operating
4. Auto-tuning indicator: turns ON when auto-tuning
5. Control output operation indicator: turns ON when control output is ON. Does not operate when the control output
6. Event output indicator: turns ON when the according event output is ON.
7. Mode key: enter parameter group, return to RUN mode, switch parameters, save setting values
8. Auto-tuning key: hold the key for 3 sec to start auto-tuning. Hold the key for 5 sec while auto-tuning to stop auto-tuning.
9. Setting keys: enter SV change mode, switch fields, change value
(
key in the dotted line is only available in TZ4M and TZ4L models)
10. Key adjustment order chart
SV Setting
①RUN mode
②SV setting mode
The setting field will blink.
J-148
S/W 2
1 1
mA V
2 2
mA V
2 2
mA V
6
5
9
10
is current output.
※ The Event 2 output indicator does not operate in TZ4SP.
※ When changing the previous SV of 0℃ to 170℃,
key
(
) key: Switch fields
,
key: Change values
● Detaching the case
Press the front case then pull the
case to detach the case from the
body.
Configure the internal switches as
input type.
1
2
3
4
7
8
key
6
5
9
③Complete SV setting