Galaxy 790.6000 Series Посібник з використання та догляду - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник з використання та догляду для Діапазони Galaxy 790.6000 Series. Galaxy 790.6000 Series 16 сторінок. Gas range
Також для Galaxy 790.6000 Series: Посібник з використання та догляду (16 сторінок)
Друкувати сторінку
Fig. 1
or
use
a Nail
Fig. 2
about45
_/'degrees
Oven Door
Hinge
Fig. 3
_
Care & Cleaning
Removing
and Replacing
the Oven Door
The door is heavy. For safe, temporary storage, lay the door flat
with the inside of the door facing down.
To Remove
Oven
Door:
1.
Open oven door completely
(horizontal
with floor-
See Fig. 1).
2.
Remove
2 screws
located
on the inside
of the oven door liner (See A Fig. 2)
3.
Insert the 2 screws
into the door hinge holes located
on the side ofthe
hinge arm, one
into each hinge (See B Fig. 2).
4.
Close oven door until the door stops (Do not force the door to close any further).
The
placement
of these
screws
should
keep door open in about a 45 degree
position.
5.
Grasp oven door firmly on both sides and slide door up and off hinges atthe
same angle.
(See Fig. 3)
6.
To clean oven door, follow
the instructions
in the Care & Cleaning
table (page
11 ).
To Replace
Oven
Door:
1.
Be sure the hinge arms remain
atthe45
degree angle position.
Be sure the screws
are
still locking
the hinge
arms from moving.
If the screws
fall out of the hinge holes, the
_'t
_.
hinge(s)
may snap back against
the oven frame
and could pinch fingers
or chip the
_';_
porcelain
finish
on the oven front frame.
2.
Hold door at the sides
near the top while resting
the lower front of door on your knee.
.....
Insert the door channels
at the bottom
of door over the door hinges,
(See Fig. 3).
_s?_
3.
Allowthedoortoslidedownintothedoorhingesevenlyatthesame45degreeangle.
_ff . ...
The hinge arms should
be inserted
into the bottom
corners
as far as they can go.
4.
Open door completely
(horizontal
with floor) and remove
both screws
from holes in
door hinges.
5.
Reinstall
the 2 screws
into the door liner (See C Fig. 2).
6.
If the door is not in alignment
with the oven frame,
remove
door and repeat
the above
steps.
13