Galaxy Top mount Refrigerator Інструкція з використання та догляду - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з використання та догляду для Діапазони Galaxy Top mount Refrigerator. Galaxy Top mount Refrigerator 16 сторінок.
Також для Galaxy Top mount Refrigerator: Посібник користувача (17 сторінок)

Друкувати сторінку
IRstallatiorl
o Connecting
Optional
Ice Maker
To Water Supply
To avoid electric
shock, which
can cause death or severe personal
injury, disconnect
the
refrigerator
from electrical
power before connecting
a water supply line to the refrigerator.
To Avoid Property
Damage:
-
Copper tubing
is recommended
for the water supply line. Water supply tubing made of 1A" plastic is not
recommended
since it greatly increases the potential for water leaks. Manufacturer wilJ not be responsible
for
any damage if plastic tubing is used for supply line.
•
DO NOT install water supply tubing
in areas where temperatures
fall below freezing.
•
Chemicals
from a malfunctioning
softener can damage the ice maker, ff the ice maker is connected
to soft
water, ensure that the softener is maintained
and working property.
IMPORTANT: Ensure that your water supply line connections comply with all local plumbing codes.
Before Installing
The Water Supply Line, You W/fl Need
,,
BasicTools:
adjustable wrench, flat-blade screwdriver, and Phillips
TM
screwdriver
o
Access to a household cold water line with water pressure between 20 and 120 psi.
•
A water supply line made of ¼ inch (6.4 mm) OD, copper tubing or braided water line. To determine the length of
copper tubing needed, you will need to measure the distance from the ice maker inlet valve at the back of the
refrigerator to your cold water pipe. Then add approximately 7 feet (2.1 meters), so the refrigerator can be moved out
for cleaning (as shown).
A shutoff valve to connect the water supply line to your household water system. DO NOT use a self-piercing type
shutoff valve.
o
A compression nut and ferrule (sleeve) for connecting the water supply line to the ice maker inlet valve.
To Connect Water Supply Line To Ice Maker Inlet Valve
1.
Disconnect refrigerator from electric powersource.
2.
Place end of water supply line into sink or bucket. Turn ON water supply
and flush supply line until water is clear. Turn OFF water supply at shut
off valve.
3.
Unscrew plastic cap from water valve inlet and discard cap.
4.
Slide brass compression nut, then ferrule (sleeve) onto water supply line,
as shown.
5.
Push water supply line into water valve inlet as far as it wiii go (¼ inch).
Slide ferrule (sleeve) into valve inlet and finger tighten compression nut
....
onto valve. Tighten another half turn with a wrench; DO NOT over tighten.
6.
With steel clamp and screw, secure water supply line to rear panel of
refrigerator as shown.
7.
Coil excess water supply line (about 2Y2turns) behind refrigerator as shown
and arrange coils so they do not vibrate or wear against any other surface.
8.
Turn ON water supply at shutoff valve and tighten any connections that
leak.
9.
Reconnect refrigeratortoelectrical
powersource.
10. To turn ice maker on, lower wire signal arm (see ice maker front cover for ON/
OFF position of arm).
Clamp
Brass
Compression
Vanve runlet
Water Valve
from
household
water supply
ice. Air in new plumbing lines may
cause ice maker to cycle two or three times before making a fu!! tray of !ce_New plumb!ng may cause !ce to be discobred
or have poor flavor. Discard ice made during the first 24 hours.