909 12V2BLI Інструкція з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Дриль. 909 12V2BLI. 909 12V2BLI 20 сторінок. 12v lithium drill driver

Do not put pressure on the drill, such that it slows the
motor down. Allow the drill bit to cut without pressure.
You will get better results and you will be taking better
care of your tool.
Keep the area free of tripping hazards.
Do not let anyone under 18 years operate this tool.
Only use accessory bits in good condition.
Before drilling, check that there is sufficient clearance for
the drill bit under the workpiece.
Do not touch the bit after operation. It will be very hot.
Keep your hands away from under the workpiece.
Never use your hands to remove sawdust, chips or waste
close by the bit.
Rags, cloths, cord, string and the like should never be left
around the work area.
Support the work properly.
If you are interrupted when operating the drill, complete
the process and switch off before looking up.
Periodically check that all nuts, bolts and other fixings are
properly tightened.
When using the drill, use safety equipment including
safety glasses or shield, ear defenders, and protective
clothing including safety gloves. Wear a dust mask if the
drilling operation creates dust.
If in doubt, do not plug in the tool. Using a power source
with a voltage less than the nameplate rating is harmful to
the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who use
and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards.
Children and frail people must not use this tool. Children
should be supervised at all times if they are in the area in
which the tool is being used. It is also imperative that you
observe the accident prevention regulations in force in your
area. The same applies for general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible
to eliminate all residual risk factors. The following hazards
may arise in connection with the tool's construction and
design:
Damage to the lungs if an effective dust mask is not worn.
Damage to hearing if effective ear defenders are not worn

Additional safety instructions for the charger

Your 909 tool with Lithium Ion batteries may only
be charged with the specific designed 909 Lithium
Ion battery charger purchased with the tool. IT IS
DANGEROUS TO USE ANY OTHER BATTERY
CHARGER TO CHARGE YOUR TOOL. Do not attempt
to charge the battery pack with any other charger than
the one supplied.
If there is a problem with the battery or the tool, take
it to your nearest Authorised Service centre or phone
and speak with an experienced 909 Customer Service
Representative for assistance in rectifying your problem.
Before using the charger, read all the instructions, labels
and cautionary markings on the charger and battery pack
as well as the instructions on using the battery pack.
Do not use the charger if it has been subjected to a
heavy knock, dropped or otherwise damaged in anyway.
Take the charger to an authorised service centre for a
check or repair.
Do not disassemble the charger. Phone and speak with
an experienced 909 Customer Service Representative or
contact a power tool repair centre for assistance. Opening
7