dbx iEQ-31 Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису dbx iEQ-31. dbx iEQ-31 20 сторінок. Graphic eq
Також для dbx iEQ-31: Посібник користувача (16 сторінок), Технічні характеристики (2 сторінок), Короткий огляд (4 сторінок)

iEQ

Rear / Front Panels

Front Panel

iEQ-15 - dual channel 15 band graphic equalizer

iEQ-31 - dual channel 31 band graphic equalizer

Input Gain Control

This control sets the signal level to the equalizer� It is capable of -12dB to +12dB of gain� Its affect is

apparent by viewing the OUTPUT LEVEL bar graph�

EQ Bypass Button

This button removes the graphic equalizer section from the signal path� The BYPASS button does not,

however, affect the INPUT GAIN, AFS, PeakStopPlus

LIMITER , or LOW CUT filters� This button

lights red when the EQ is in bypass mode

RANGE +/-15 Button

This button selects which of the two boost/cut ranges the equalizer will use, either ±6dB or ±15dB� The

button lights red when the ±15dB range is selected�

Output Level Bar Graph

These four LEDs indicate output level of the equalizer� It monitors the level at the output of the

equalizer after all other processing, including the limiter�

Clip LED

This LED lights whenever any internal signal level reaches 1dB below clipping, which may occur when

any of the following happen: 1) the input signal is "hotter" than +20dBu, 2) excessive gain is applied by

the input gain control, or 3) excessive boost is applied using the frequency sliders�

Gain Reduction Meter

These four LEDs indicate the amount of gain reduction being induced by the setting of the

PeakStopPlus

LIMITER control as the signal level from the graphic EQ section exceeds this limiter

threshold setting�

iEQ User Manual