909 KHD1050K Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Дриль. 909 KHD1050K. 909 KHD1050K 12 сторінок. 1050w rotary hammer drill
Друкувати сторінку•
When using the drill, use safety equipment including
safety glasses or shield, ear defenders, and protective
clothing including safety gloves. Wear a dust mask if the
drilling operation creates dust.
If in doubt, do not plug in the tool. Using a power source
with a voltage less than the nameplate rating is harmful to
the motor.
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who use
and service the machine have to be acquainted with this
Manual and must be informed about its potential hazards.
Children and frail people must not use this tool. Children
should be supervised at all times if they are in the area in
which the tool is being used. It is also imperative that you
observe the accident prevention regulations in force in your
area. The same applies for general rules of occupational
health and safety.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible
to eliminate all residual risk factors. The following hazards
may arise in connection with the tool's construction and
design:
•
Damage to the lungs if an effective dust mask is
not worn.
•
Damage to hearing if effective ear defenders are
not worn.
Wear goggles
Wear earmuffs
Wear a breathing mask
The tool must be used only for its prescribed purpose.
Any use other than those mentioned in this Manual will
be considered a case of misuse. The user and not the
manufacturer shall be liable for any damage or injury
resulting from such cases of misuse.
The manufacturer shall not be liable for any changes made
to the tool nor for any damage resulting from such changes.
Even when the tool is used as prescribed it is not possible
to eliminate all residual risk factors. The following hazards
may arise in connection with the tool's construction and
design:
•
Damage to the lungs if an effective dust mask is not worn.
•
Damage to hearing if effective earmuffs are not worn.
WARNING.
We recommend the use of a residual current
device with a residual current rating of 30mA or less.
Unpacking
Due to modern mass production techniques, it is unlikely
that your 909 Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Contents of carton
The Rotary Hammer Drill is supplied with the following
accessories:
•
Auxiliary handle
•
Depth gauge
•
Dust cap
•
Pin wrench
•
Grease pot (with general machinery grease)
CAUTION.
Always ensure that the drill is switched off and
plug is removed from the power point before making any
adjustments.
Assembly
The drill is packed fully assembled.
6