909 20VHTG Інструкція з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Тример 909 20VHTG. 909 20VHTG 16 сторінок.

Друкувати сторінку

Safety features incorporated

with tools using this battery pack

Product overload

These tools are fitted with an overload protection system. If

the tool is excessively forced, or the task being performed

is too great for the tool, the tool will automatically go into

an overload mode. When the tool goes into overload, the

tool will automatically and suddenly STOP. To reset the

overload, simply release the trigger. When the trigger is

pressed again, the tool will restart. Resume work after the

overload has been reset, but reduce the size of the cut or

reduce the force on the tool to make the cut.

CAUTION.

Do not continue to overload the tool and

constantly reset the overload. Doing this will cause the

battery cells to overheat.

Temperature cut out

If the tool is constantly overloaded, or the tool is used

constantly at maximum rating in high ambient conditions,

the battery cells may over heat causing the battery pack to

shut down. The tool will not re-start until the battery pack has

cooled.

If this occurs you will need to immediately stop working and

allow the battery cells to cool down.

To reduce the temperature of the cells remove the battery

pack from the tool and place the battery pack in a free air

environment, out of direct sunlight or any other heat source.

DO NOT force cool the pack in any way. Do not place in

refrigerators or freezers.

When the battery pack has cooled down it can again

be used to operate the tool, as long as the load or the

conditions causing the original excessive temperature

has been corrected.

20VHTG IM ed6.indd 12

Low voltage cut out

The battery pack used on this tool is fitted with a low

voltage cut out feature within the circuitry.

The low voltage cut out feature operates when the voltage

drops below a preset value. This feature automatically

stops the tool from operating (similar to that of the over

load condition). When this condition occurs you will need

to either insert another battery into the tool or recharge the

existing battery.

The low voltage cut out feature has been added to

maximise the tool's life. When this occurs, recharge the

battery pack by following the battery charging section in

this manual.

Note:

Attempting to restart the tool without either recharging

the battery or installing another battery (with charge) will

lead to the tool restarting and then stopping again, after only

a few seconds of operation.

28/8/13 8:10:04 AM