DYNAPAR M21 Series Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для Конвертер мультимедіа DYNAPAR M21 Series. DYNAPAR M21 Series 6 сторінок.

Mount Encoder

Set hub over motor shaft:

While holding hub in position, slide encoder over motor

shaft. Confirm that encoder through-holes match

tapped holes on motor.

Tighten Hub Clamp

Determine hub clamp type:

M21 encoders are available with exposed (step 7a)

or blind (step 7b) hub clamp screws.

For exposed hub clamp screw, go to step 7a.

For blind hub clamp screw, go to step 7b.

Page 4

Application Assistance 1.800.234.8731 (847.662.2666)

Polígono Industrial O Rebullón s/n. 36416 - Mos - España - [email protected]

Index Alignment

Align index mark:

Turn hub until clamp slit or index scribe mark is in

line with edge of housing post as indicated. Note

difference for "exposed hub clamp" and "blind hub

clamp" models.

Blind Hub

Clamp Models

Exposed Hub Clamp

Use provided Allen wrench:

Hold the hub seated in the base and tighten the

clamp screw to 3 lb – in (34 N – cm). Take care

not to rotate hub from aligned position.

+34 986 288118

Servicio de Att. al Cliente

Exposed Hub

Clamp Models