909 ES99 Інструкція з експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Газонокосарка 909 ES99. 909 ES99 20 сторінок. 99cc 400mm (16") electric start 4 stroke petrol lawn mower

Друкувати сторінку

3. Push the catcher down until it

locks into place.

4. Release the discharge guard

to secure the catcher in place

between the 2 ribbed locking

notches.

Note.

Always empty the catcher

before it has reached maximum

capacity, otherwise it will decrease

the performance of the mower.

Tip.

Do not leave clippings in the

catcher for extended periods.

WARNING.

Check the catcher

frequently for cracks and wear

and replace it if damaged.

Cutting height adjustment

WARNING:

Stop the engine and unplug the spark plug

before any repairs or maintenance operations.

This mower has one lever to easily adjust the cutting height.

There are 7 height settings (20-70mm).

1. To decrease the cutting height

pull the height adjustment

lever (9) out and move it up a

notch to the left, towards the

handlebar.

2. To increase the cutting height

pull the lever out and move

it down a notch to the right,

towards the engine.

Note.

If you are unsure of which cutting height to use, begin

with a high setting and trial a small section of lawn, then

check the appearance of the lawn. Then readjust if necessary.

Preparing the lawn mower

It is important to check the lawn mower before you

commence operating the unit.

IMPORTANT.

Ensure that the engine is fully filled with oil

and fuel. When leaving the factory, this lawn mower has NO

OIL in the engine and no fuel in the fuel tank.

Note.

Failure to add sufficient oil to the motor will cause

damage to the motor which is NOT covered under warranty.

Checking the oil

1. Move the lawn mower to

a level surface and clean

around the oil filler cap (11) .

2. Remove the oil filler cap with

dipstick and wipe it with a

clean cloth. For new units,

ADD 0.4L of SAE 10W/30

oil. Replace the cap and

retighten.

3. Remove the dipstick again and check the oil level, the

oil should be at the full ('max')

mark.

4. If oil is required add it slowly

with SAE 10W/30 oil.

(The oil capacity is 0.4L).

Do not overfill.

5. Retighten the oil filler cap firmly

before starting the engine.

Do Not fill above the Maximum

Marking. Do not operate the motor if the oil level is not within

the textured marking (between the "min" and

"max" markings)

Max