909 BL18L Інструкція з експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Повітродувка 909 BL18L. 909 BL18L 13 сторінок. 18v sweeper/blower
Друкувати сторінкуFitting and removing the battery pack
To remove the battery pack
from the blower firmly press the
battery release tabs (4) at either
side of the battery pack, and slide
the battery backward out of the
tool.
To install the battery pack, align
rails, on the tool with the tabs
on the battery pack and slide the
battery pack on to the blower. Ensure the battery pack is
sitting straight on the foot and correctly entering the runners.
The battery should slide fully on to the drill foot until the
battery pack "clicks" into position.
Battery charging
•
The battery supplied with this
tool is model number 2G18LB.
•
The Charger Pack supplied
with this tool is model number
2G1835LC.
•
The Charger Adaptor supplied
with this tool is model number
2G1835LA.
Note.
Only use the supplied
batteries, charger and adaptor.
IMPORTANT.
Before plugging
in the power supply from the
charger to the slim line adaptor
always ensure that the plug is
switched off at the mains.
IMPORTANT.
The battery will be
fully charged after approximately
3–5 hours, remove it from the adaptor after this time.
Do not leave a battery charging for longer than 24 hours.
1. Align and slide the slim line
adaptor onto the battery
until the battery pack latches
"click" into position. Check
the adaptor is flush with the
battery and there is a firm
connection.
2. Connect the power supply
from the charger (5) to the slim
line adaptor via the socket in
the rear of the adaptor housing.
3. Plug in the charger and switch
on. The red LED indicator will
show power to the adaptor and
that charging is taking place.
4. The battery charging time is
approximately 3 - 5 hours to
charge a low charged battery, but will be shorter if the
battery is already partially charged. The red LED goes
out when the charging cycle is complete. Turn off the
charger power supply from the mains and then remove
the battery from the adaptor.
WARNING.
Only use charger model 2G1835LC with the
adaptor model 2G1835LA) that is supplied for the model
2G18LB battery pack.
To obtain the best life for the battery
For battery storage and when the blower is not being used,
it is advised to charge the battery to approximately half
charge. Leaving the battery in the fully charged condition
can shorten the cell life.
Short charging is acceptable with these cells.
Prevent constant overloading of the blower.
Avoid allowing lose items like screws or nails etc. to be
stored with battery packs as these or similar items can
short battery packs and cause a fire or explosion.
Always unplug the charger when not in use and store in
a dry secure place.
11