Dynaphos Expert QS-300 Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Освітлювальне обладнання Dynaphos Expert QS-300. Dynaphos Expert QS-300 8 сторінок. Expert qs series
Друкувати сторінкуMounting the flash and preparing to work
Mount the flash unit onto an appropriate light stand and fix it. Adjust the horizontal angle and
secure the handle.
To take down the protective cap or mounted accessory, hold down the mount release button (pic.
1), turn the accessory counterclockwise and pull it forward. To mount an accessory, proceed the opposite
way as matching the feathers of the bayonet with the corresponding holes of the flashe body. Please notice,
that to installe the modeling lamp, first you need to unmount the glass cover dome.
To work with photographic umbrella use standard 18 cm reflector and place it with the umbrella
outfit matching the flash umbrella holder. Please, pay attention that the umbrella holder is located in the
upper side of the flash (pic. 3)! The umbrella is fixed due to rubber dampers so you need to apply moderate
effort to overcome their resistance.
Make sure that the power switch
the AC power socket 13. Plug in the power cable and turn on the flash by placing the power switch in position
"I". Make a test flash as pressing the "Test" button 6.
(check page 2)
9.
pic. 1
3
is in "0" position and place the power cable in
pic. 2
Guide
pic. 3