Dynaphos Expert QS-600 Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Освітлювальне обладнання Dynaphos Expert QS-600. Dynaphos Expert QS-600 8 сторінок. Expert qs series
Друкувати сторінкуSavety
1
Thank you for choosing DYNAPHOS studio lighting equipment! Before you proceed further, please read the
instruction manual.
Attention! Please, follow the savety instructions!
• Keep out of reach of children!
• Make sure that the power outlet you plug the flash is working correctly.
• Do not disassemble or modify! There are high-voltage components inside the unit. Repairs should only be
performed by authorised service personnel!
• Do not touch the lamp cap when the flash or modeling lamp is working due to risk of burns or electic shock!
• Disconnect the flash from the power supply when mounting accessories on or off or when you're cleaning
the flash unit.
• Durint operation, some of the light control accessories may be heated to high tempetures! Wait to cool
down before you mount them off.
• During operation, do not cover the flash! Make sure that the flash unit will not be activated in the vicinity
of inflammable gases or liquids. Risk of explosions!
• Do not expose the flash unit to water drops and splashes!
• In every 30 continuous flashes at full power, leave the flash to cool down for about 3 minutes. Overheating
will occur if it is used continuously without cooling down.
• Do not flash directly into eyes from a close distance! Direct flashing into the eyes of person or animals can
cause damage to the retina and severe disruption of the vision – up to and including permanent blindness!
• If the housing has been damaged in such a way that internal components are exposed, the flash unit may no
longer be used. Disconnect from the power supply! Do not touch any internal components. HIGH VOLTAGE!
• Use only light controlling accessories autorized by DYNAPHOS Ltd.