DynaQuip WaterCop Classic Посібник користувача та інструкція з монтажу - Сторінка 17

Переглянути онлайн або завантажити pdf Посібник користувача та інструкція з монтажу для Вимірювальні прилади DynaQuip WaterCop Classic. DynaQuip WaterCop Classic 20 сторінок.

Друкувати сторінку

Changing Digital Codes

Codes on all control units and transmitters are set at the factory and should not

require alteration . If you use other wireless products in your home (garage door

openers, etc . ) , there is a slight chance of interference with the signal . The following

instructions will aid in resetting the code .

Important: All transmitters and the control unit must have the same code setting!

Changing the Actuator Code

Disconnect power to receiver unit by unplugging power cord .

1 . Remove cover using the 4 screws located in the corners of the cover .

2 . Locate code switch block (see illustration below) . Switches are numbered

1 through 8 .

3 . Arrange the switches in any combination (on or off position) . Write down the

code combination you selected . Example: 1-on, 2-off, 3-off, 4-on, 5-off, 6-on, 7-off,

and 8-off .

4 . Some WaterCop® receivers may have 6 dip

switches . To match codes between 6 and 8

dip switch units, set switches 1–6 exactly the

same on both units . Switches 7 and 8 must

remain in the "on" or "up" position .

5 . Carefully tuck wires completely into case

and reinstall cover .

6 . Reconnect power by plugging the power

cord into power receptacle .

Changing the Transmitter Code

1 . Remove transmitter cover .

2 . Locate code switch block . Switches are

numbered 1 through 8 .

3 . Arrange the switches in the exact combination as the code that you set in the

receiver . It is important that the same exact code be set in the receiver and all

transmitters . If the codes differ, the unit will not function properly .

4 . Some WaterCop® transmitters may have 6 dip switches . To match codes between

6 and 8 dip switch units, set switches 1-6 exactly the same on both units . Switches

7 and 8 must remain in the "on" or "up" position .

5 . Test each transmitter to ensure that the unit is functioning properly .

6 . If not, verify that all codes are set the same . When all transmitters are functioning

properly, your WaterCop® Classic System is on duty to help protect your home from

damage due to plumbing leaks .