Galaxy Control Systems 635 Series Робочий аркуш - Сторінка 4
Переглянути онлайн або завантажити pdf Робочий аркуш для Контролер Galaxy Control Systems 635 Series. Galaxy Control Systems 635 Series 5 сторінок. System galaxy installation worksheet
Друкувати сторінку
9.
At the PC/Event Server, verify the 635-Controller is connected to the GCS Event Service. Do this by running the GCS
Service Monitor app, which is found on your local PC drive C:\\GCS\System Galaxy\Utilities folder.
The CPU must be connected to the LAN.
Open the Utilities folder.
a)
Right-click GCSSvcMgr.exe file.
b)
Choose 'Run as administrator'.
c)
Click [ Fill Service List ] button.
d)
Select the GCS Event Service.
e)
Click [Connect to Service] button.
f)
The 635-Controller should show in
g)
Controller Connections tab.
10.
Verify the CPU board flash version matches the Flash released with your version of System Galaxy. In System Galaxy
software screen, open Help > About window from the SG Help menu to see the correct flash version.
Update CPU Flash via embedded CPU web page:
a)
Enter the CPU's IP Address into the browser address bar. The embedded web page will display.
b)
Click the Update Firmware link and choose the 635-CPU .bin file to load flash to the CPU.
c)
After the CPU is finished, select Clear Auto to begin flashing the daughter boards ( i.e. DRMs, DIOs, etc. ).
Or optional method – you can Update CPU Flash using the GCS Loader Utility:
IMPORTANT: you must have already installed the
software and programmed your clusters and controllers
into the software programming screens.
C
User Guide
hapter-5 First Time Start-up for instructions to add
clusters, controllers. NOTE: Chapters 8 and 9 cover adding Clusters
and Controllers in depth. Chapter 6 covers the Loader features in
depth.
You must sign-in to System Galaxy as a master operator.
A.
In Hardware Tree, right-click the cluster icon and select
the 'Load' from the menu to open the Loader Utility.
B.
Select the Loop/Cluster and Controller.
C.
Select the EZ80 tab and click [Browse] button.
D.
Open the "600" folder. Select the 635-CPU .S28 flash
file, and click [Open] button to link flash file to Loader.
E.
Click [Begin Flash Load] button and allow load to finish.
F.
Click [Burn Flash] to permanently burn flash into CPU.
G.
Click [Allow Board Updates] to update daughter boards
(DRM, DIO, DSI, etc.).
! Never interrupt power when flashing boards or burning flash. Doing so can damage boards and cause undesirable operation.
Continue on next page ...
See
SG Software
Page 4 of 5