909 52299 Посібник користувача - Сторінка 19

Переглянути онлайн або завантажити pdf Посібник користувача для Інвертор 909 52299. 909 52299 20 сторінок. 3500w inverter generator with pure sine wave

Друкувати сторінку

Troubleshooting

Trouble

Possible cause

1. Low on fuel or oil content

Engine will not start

2. On/Off switch (4) in "Off" position

3. Faulty spark plug (23)

4. Choke lever (19) in wrong position

5. Fuel shut-off valve in closed position

6. Unit loaded during start-up

7. Spark plug (23) wire loose

8. Old fuel in carburetor

1. Faulty receptacle

No electrical output

2. Overload has been triggered

(red Overload light on).

3. Faulty power cord

4. Master 240Va.c switch (13) turned off.

1. Overload

Repeated overload

2. Faulty cords or equipment

1. Generator overloaded

Generator overheating

2. Insufficient ventilation

1. Check oil level

Generator keeps stopping,

or is operating rough

2. Generator not sitting on flat

and level surface

3. Motor needs to be cleaned of carbon

For other issues not covered in this chart, please call Customer Service on 1800 909 909.

e-mail: [email protected]

MODEL: №. INF3800A • 52299

3500W Digital Inverter with Pure Sine Wave

Suggested remedy

1a Fully fill tank. Ensure fuel is fresh

1b Ensure oil is at the the correct level.

Refer page 20-21 of this manual.

1c Ensure the generator is horizontal and

not on an angle

1d Turn Off the fuel tap / lever (26).

Loosen the carburettor drain screw.

Allow the fuel in the carburettor bowl

to totally drain. When the fuel has

stopped draining, open the fuel tap /

lever (26) on the tank and fuel starts

running out of the carburetor drain. If

so, tighten the screw on the drain and

allow the carburetor to fill with petrol.

1e If the fuel from the tank does not pass

through the carburetor drain above,

turn off the fuel tap / lever (26) and

clean the fuel filter in the bottom of the

fuel tap. Refer to page 30-31.

2. Press the On/Off switch (4) to the 'On'

position as indicated by an "I" .

3. Replace or clean spark plug (23)

4. Adjust choke lever (19) accordingly

Refer to page 22.

5. Open fuel shut-off valve

6. Remove load from unit

7. Attach wire to spark plug (23)

8. Fuel will deteriorate in the carburetor

fuel bowl very quickly. Open the drain

screw in the bowl of the carburetor until

fresh fuel runs through.

1. Have service centre replace receptacle

2. Remove all appliances. Stop the

generator, and restart. Reconnect

appliances but with reduced load.

3. Have an electrician replace cord.

4. Check the master 240Va.c switch (13)

is ON.

1. Reduce load

2. Check for damaged, bare, or frayed

wires on equipment. Replace.

1. Reduce load

2. Move to adequate supply of fresh air

1. Add oil so oil is at the correct level.

Refer page 20-21 of this manual.

2. Move generator to a level and

flat surface

3. Remove, check and clean spark

arrestor (11) if needed.

Remove, clean or replace spark plug (23)

AFTER SALES SUPPORT

1800 909 909

(toll free)

3500W Digital Inverter with Pure Sine Wave

Specifications

AC output:

240Vac ~ 50Hz

Rated power:

3200W

Peak power:

3500W

Phase:

Single

Power factor:

cosφ =1

Displacement:

182cc

Motor:

4 stroke

No load speed:

3000 RPM

Approximate Generator

Run time:

(Hours per full tank)

Full Load:

5.5 Hours

50% Load:

9 Hours

25% Load:

12 Hours

Fuel tank capacity:

10.5L

Fuel type:

Unleaded

Oil tank capacity:

600ml

Oil type:

4 Stroke (SAE 10W-30)

Net weight:

31kg

(with wheels and handle)

Spark plug:

NGK BPR6ES

Product Dimensions:

(without wheels or carry handle) 52cm x 41cm x 46cm (L x W x H) +/- 10%

Noise rating:

69 dB (A) (taken at 7.5 metres)

You must wear ear protection at all times.

This product complies with:

Safety – AS 2790-1989/Amendment 1-1989

CISPR12:2009 ed6