iHealth BPM1AE Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Монітор артеріального тиску iHealth BPM1AE. iHealth BPM1AE 17 сторінок.

If Wi-FI set done, the monitor will connect to cloud at 2 hour

intervals. If new version software release the monitor will updata

automatic when it connect to cloud.

The monitor can sync clock with cloud automatic when it connect to

cloud.

OPERATING PROCEDURES

Insert the cuff tubing connector into the air port in the side

of the monitor. Make sure that the connector

is completely inserted to avoid air leakage

during blood pressure measurements.

Avoid

compression or restriction of the

connection tubing during measurement，

which may cause inflation error, or harmful injury due to

continuous cuff pressure.

When the monitor in turn off mode, insert the cuff tubing

connector the monitor will turn on.

a. Pull the cuff end through the

metal

outward (away from your body).

b. Place a bare arm through the cuff

and position the cuff 1/2"(1-2 cm)

above the elbow joint.

c. Tighten the cuff and close it by

pulling it towards your body, securing it closed with the Velcro

fastener.

d. While seated, place your hand palm-side up in front of you on

a flat surface such as a desk or table. Position the rubber tube

in the middle of your arm aligned with your middle finger.

e. The cuff should fit comfortably, yet snugly around your arm.

You should be able to insert one finger between your arm and

the cuff.

Remember to:

1. Make sure that the appropriate cuff size is used; refer to

the cuff circumference range in "SPECIFICATIONS".

2. Measure on the same arm each time.

3. Stay still during measurement. Do not move your arm, body,

or the monitor.

loop,

positioning