Galaxy Print Finishing VR-930 Інструкція з експлуатації - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Виробники буклетів Galaxy Print Finishing VR-930. Galaxy Print Finishing VR-930 15 сторінок.
Друкувати сторінкуMissing staples or un-qualified staple in-put:
Unqualified staples
Incorrect staple type
or specification
Staple Pusher has
been put in the wrong
direction
Residue is inside the
Staple Head
Staple Pusher is
scratched or worn out
If you cannot fold or if an un-qualified booklet has been folded & stapled:
Settings for the Fold
& Staple features are
not correctly set
Too many sheets
are inserted or the
material is too rigid
Folding line is not
located in the centre
of the booklet, or is at
a slanted angle
Dirty rollers
The 2 staples are not
properly centered in
the booklet
Use only our standard 26/6 & 26/8 staples. See
Page 4.
Use only our standard 26/6 & 26/8 staples. See
Page 4.
The Staple Pusher should be shown towards the
rear of the machine. See Page 3.
First, remove the Staple Head from the machine
and then unscrew the front plate of the Staple Head.
Clean the Staple Head and then re-install it to the
machine. Make sure the Staple Head latch is locked
before you operate the machine. Follow the
instructions on Page 3 to remove/install the Staple
Heads.
Follow the instructions on Page 3 to change the
Staple Pusher.
Follow the instructions on Page 2 to set up the Fold
& Staple features correctly.
1. Do not insert more than 16 sheets of paper into
one run.
2. Do not insert materials that are too thick or too
rigid. Do not insert materials other than paper.
1. Properly adjust the Left & Right Side Guides.
If the Side Guides are too far apart, paper can be
unparallel as it is inserted into the machine. On the
other hand, if the Side Guides are set too tightly,
paper can curl up during folding, which can result in
incorrect stapling. See Page 5 for instructions.
2. Properly adjust the Paper Depth Adjustment
Knob, so that the machine folds in the centre of the
sheets. See Page 5 for instructions.
Clean rollers using a soft and damp cloth. Never use
chemical or alcohol base liquidsas they may
damage the roller.
1. Properly adjust the Left & Right Side Guides.
See Page 5.
2. Re-install Staple Heads to the correct positions.
See Page 3.
11