iHealth HS5 Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Ваги iHealth HS5. iHealth HS5 15 сторінок. Wireless body analysis scale
Також для iHealth HS5: Посібник користувача (15 сторінок), Посібник із швидкого старту (4 сторінок), Посібник із швидкого старту (20 сторінок), Посібник користувача (14 сторінок)

interference that may cause undesired operation.

15. Changes or modiﬁcations not expressly approved by iHealth

Lab Inc. invalidate the user's warranty for this equipment.

16. This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference

to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following

measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for

help.

17.

This device complies with Industry Canada license-exempt

RSS standard(s). Operation is subject to the following two

conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including

interference that may cause undesired operation of the

device.

TROUBLESHOOTING

PROBLEM

Scale model name is not listed

on the Bluetooth Menu of the

iOS device

SOLUTION

Make sure Scale is on "Set"

status by pressing the "Set" button

on the back of the Scale.