Autonomic Mirage m-401e Посібник - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник для Підсилювач Autonomic Mirage m-401e. Autonomic Mirage m-401e 13 сторінок. Multi-zone digital amplifier

Друкувати сторінку
Notes
• When a command is sent to an amplifier
it will first be transmitted on the control
bus and then returned to the PC (Home
Automation System). If an error occurs an
error will be returned instead of the origi-
nal command. The PC (Home Automation
System) needs to ignore its command
when it is returned.
• A Standby ON command implies that the
amplifier is not muted, if the amplifier
was previously Off, a mute command
must follow the Standby command if it is
muted.
• Not all Command and Data commands
are covered in this document.
• The expected reply for the "Send all
Parameters" command (09) is >144 bytes.
All command fields listed in this document
are contained in the reply. The reply also
contains advanced commands not listed
in this document. The home Automation
or PC's buffer should be large enough to
receive and process the 144-byte reply.
a. Zone 2 links to Zone 3.
b. Since Zone 2 is no longer linked to
Zone 1, Zone 1 will no longer be
linked to Zone 2.
c. Since Zone 3 is no longer linked to
zone 4, Zone 4 will no longer be
linked to Zone 3.
Example strings:
• 010A01: Standby ON command for Zone
10 amplifier.
• 012A01: Standby ON command for Zone
10 preamplifier.
• 060002: +2db Treble setting on Zone 0.
• 03IF02: Select Source 7 on Zone 31.
Acknowledgments – FreeRTOS – uIP
The M-401e rmware is based in part on FreeRTOS.org
downloaded from their of cial website. The following copyright and statements for uIP TCP/IP stack are required by license: Copyright © 2001-2003, Adam Dunkels. All rights reserved.
1. Redistribution and use in source & binary forms, with or without modi cation, are permitted provided that the following conditions are met.
2. Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer.
3. Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution.
The name of the author may not be used to endorse or promote products derived from this software without speci c prior written permission.
THIS SOFTWARE IS PROVIDED BY THE AUTHOR "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED
TO, PROCUREMENT OF SUBSTITUTE GOODS
©2006–2016
Autonomic Controls,
Inc.. Autonomic, eAudioCast, and TuneBridge are registered trademarks of Autonomic Controls, Inc.
All other trademarks are property of their respective owners. Speci cations are based on current revision and may change without notice. 121216
Specifi cations
Rated Output Power (FTC)
All Channels
Total Harmonic
Distortion (THD)
Damping Factor (8Ω load)
Speaker Impedance
(Z1 - Z6 L/R)
Analog Input Sensitivity
(S1 - S8 L/R)
Analog Input Impedance
(S1 - S8 L/R)
Digital Input sensitivity
Frequency Response
Tone Control
Signal to Noise Ratio
IR Output
Source Inputs
Ethernet
USB
Data
Controllers
BUS RUN
Amp On & PG Control
Zone Triggers & Presets
Power Supply
Power Consumption
Standby Power Consumption
Dimensions with feet
Weight
Height including feet
Zones
A digital copy of this manual can be found at:
http://www.autonomic-controls.com/documents/Amplifi ers/Manual_Instructions_Mirage_401e.pdf
™
V5.0.2 and the uIP TCP/IP stack. For more information on FreeRTOS.org
M·401e
55W per channel / 8Ω loads
75W per channel / 4Ω loads
0.1% (50 Watt, 8 Ω load)
10
4Ω–8Ω
0.75V RMS (Vol 100, Gain 0dB, 55W Output)
22KΩ
0dBFS
48 KHz sample rate: 10Hz - 22 KHz
96 KHz sample rate: 10Hz - 42 KHz
±12dB, 100Hz (Bass)
±12dB, 10kHz (Treble)
95dB (IHA-A, 0.75V input / unbalanced)
(6) 3.5mm Jack: IR1 - IR8 current limited to 25mA
(6) Digital Coaxial RCA, (4) Analog (L/R) RCA, (2) TOSLINK
(2) 100Base-T, MAIN IN and Switch EXT OUT
(1) USB mini-B female 5 pin
(1) 4 pole 3.5 mm terminal block connector (Data,12V, IR,0V)
(4) RJ45 sockets Keypad controller ports
(1) 4 way terminal block (0V, IR 12V & Data)
(1) 8 way terminal plug with Amp ON 1 - 8 and (2) page preset contact
closure inputs: PG1 & PG2
(1) 8 pole 3.5 mm terminal block connector
(Zone trigger 0V out, Zone trigger 1 - 8 12V out, Common, Preset 1 - 2 in)
110–240V AC 50–60Hz
650W
6W
4.0" H x 17" W x 15" D (10.2cm x 43.2cm x 38.1cm)
15.4 lb. (7 kg)
105 mm
(4) zones
Expandable to 96 zones, attaching additional M-401e or M-401e amplifi ers
™
please visit http://www.freertos.org. Source code for FreeRTOS.org™ can be
13