DCB SE-6600 Посібник із швидкого старту

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання DCB SE-6600. DCB SE-6600 4 сторінки. Serial encrypter

SE-6600 Serial Encrypter Quick Start Guide

This document guides the new user through configuration of an SE-6600 serial encrypter and

demonstrates a bench setup in which a pair of devices maintain encrypted serial port

communications. Connect two PCs' serial ports through two SE-6600 units with the encrypted

link between them, as diagrammed in Figure 1 below.

Figure 1 – Configuration for End-to-End Test (IP Addresses for Setup Only)

Requirements

1. Two SE-6600 units and knowledge of basic TCP/IP networking

2. Two PCs with a wired ethernet connection, Serial Port (or USB-to-Serial adapter cable),

terminal emulation program and any modern web browser

3. LAN cable, either straight-through or crossover, to access the LAN ports (This is a

separate cable from the one provided with the SE-6600.)

4. Null modem cable, to connect the pair of SE-6600 units to each other

Step-by-Step Procedure

1: Open the first box and note the contents: The SE-6600 serial encrypter, network cable,

"Direct PC" and "Remote PC" adapters, power supply and CDROM containing manual and

Application Notes. Power up this unit (SE-6600 "A")

2: Configure one of the PCs for use on the default LAN subnet of the SE-6600s. Use the IP

address 192.168.1.100 with a Subnet Mask of 255.255.255.0.

3: Use the LAN cable to connect the PC to SE-6600 A's LAN port, open a browser (Internet

Explorer, Firefox, Chrome, Safari), and enter

https)

http://192.168.

(NOTE that "http" is used, not

DCB, Inc.

2949 CR 1000 E

Dewey, Illinois

61840

217.897.6600 Tel

800.432.2638 Toll Free

217.897.1331