High Per 49CC MINI Посібник користувача - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник користувача для Позашляховик High Per 49CC MINI. High Per 49CC MINI 20 сторінок.

When replacing the spark plug, screw it in by hand until it stops, then tighten with a wrench.

● Brakes

● Check after cleaning

● Adjustment

To check the wear of front and rear brake pads A,

simply inspect the brakes calipers as shown in the

figure.

The thickness of the lining on the ends of the four

pads should never be less than 1mm.

Should the lining be thinner, immediately replace the

brake pads.

We recommend having the brake pads

replaced by an authorized dealer

After cleaning the motorcycle, it is good practice to:

· Take off the flywheel cover and remove any dirt

and water.

· Apply the lubricant above articulation points A and

B on the rear and front swing arm .

· Carefully clean and dry the chain-gear-position

assembly and then apply grease thoroughly in order

keep these parts in good condition as long as

possible.

· Dry well any metal parts subject to corrosion,

oxidation, etc.

The front and rear brakes are mechanically operated

disc brakes, which require periodic adjustment.

As shown in the figure, there should be 5-6 mm play.

To adjust the play, follow these steps:

-Check the play in driving position.

-If the clearance is excessive, use adjuster A on the

brake lever to obtain the desired position.

-Tighten locknut B.