Autool C100 Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Ультразвуковий очищувач ювелірних виробів Autool C100. Autool C100 5 сторінок. Fuel system cleaner

Друкувати сторінку

The operating procedure of TWC and intake manifold flushing:

Pour the TWC detergent into the bottle. Open the Ball Valve

and Air Pressure Regulating Valve to keep the air pressure as

zero.

Connect the TWC Flushing Kit to the output pipe of the C100.

Disconnect the Intake Vacuum Pipe which near the throttle

and insert the TWC Flushing Nozzle into Intake Vacuum Pipe

as shown.

Intake Vacuum Pipe

Start the engine, and open the Ball Valve slowly which be sure

to make the detergent into engine vacuum pipe very slowly.

The flushing process needs about 30 or 40 minutes.

Keep the engine speed up to 1000 rpm and press the

accelerator every 3~5 minutes to make the engine speed up to

2000 ~ 3000 rpm and keep this state for 30 seconds. Then

keep idle speed.

Do the flushing procedures as above until to exhaust the

detergent. Then stop engine and reconnect the vacuum pipe.

Start engine as idle speed for about 5 to 10 minutes to exhaust

the detergent in the pipe.

The operating procedure of Throttle body and exhaust pipe

flushing:

Pour the Throttle Body detergent into the bottle, and close the

Ball Valve of the fuel outlet pipe. Open the ball valve of the air

inlet port and connect to the compressed air. Adjust the air

pressure to about 0.5MPa（ 5kgf/cm2） and then close the

Ball Valve of air inlet port.

Connect the spray nozzle kit to the fuel outlet port of the C100.

Remove the pipe ahead of throttle before flushing as shown.

Put the spray nozzle kit in the throttle body as shown and start

the engine. And then open the Ball Valve of fuel outlet port .