Autopage RF-420LCD Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з монтажу для Автосигналізація Autopage RF-420LCD. Autopage RF-420LCD 12 сторінок. Professional vehicle security system

Друкувати сторінку

Keep wiring away from moving engine parts, exhaust pipes and high-tension cable. Tape

wires that pass through holes on the firewall to prevent fraying. Be careful of sharp edges

that may damage wires and causes short circuit.

CAUTION: Do not connect the wire harness to the control module until all wiring to vehicle

is complete.

MAIN 5 PIN WIRE HARNESS:

WHITE WIRE –PARKING LIGHT RELAY OUTPUT (+12 V 10A OUTPUT) --

Connect the WHITE wire to the parking light wire coming from the headlight switch. Do

not connect the WHITE wire to the dashboard lighting dimmer switch. (Damage to the

dimmer will result). The limitation of the WHITE wire is 10 AMP max. Do not exceed this

limit or damage to the alarm and parking relay will result.

BLACK WIRE -- SYSTEM GROUND –

This is main ground connection of the alarm module. Make this connection to a solid

section of the vehicle frame. Do not connect this wire to any existing ground wires

supplied by the factory wire loom, make the connection to the vehicle's frame directly.

BROWN WIRE-- (+) SIREN OUTPUT

This is the positive (+) output connection for the siren. Current capacity is 2 amps. Make

connection to the (+) red wire from the siren. Make the (-) black wire coming from the

siren to a good chassis ground.

RED WIRE -- SYSTEM POWER (+12V CONSTANT) --

The RED wire supplies power to the system. Connect this wire to a constant +12 volt

source.

BLUE / BLACK WIRE -- (-) HORN OUTPUT --

This wire is provided to use the existing vehicle's horn as the alarm system's optional

warning audible device. It's a transistorized low current output, and should only be

connected to the low current positive (-) output from the vehicle's horn switch.

4 PIN ORANGE CONNECTOR FOR 2 STAGE SHOCK SENSOR

Function: For both Orange Port 1 and White Port 2, Allows easy positive, negative, instant

trigger, and warn-away trigger connection with quick disconnect ability for other detection

devices.

WIRING

4. Green Wire / Warn Away Input

3. Blue Wire / Zone 4 Ground Trigger

2. Black Wire / Negative

1. Red Wire / +12Volts