AutoPets Feeder-Robot Інструкція з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Засіб для догляду за домашніми тваринами AutoPets Feeder-Robot. AutoPets Feeder-Robot 19 сторінок.
Друкувати сторінку
Setting an Automatic Feeding Schedule
via Control Panel
Portion
Quantity Indicator
Set Portion
1.
Press the Portion button once to
see the current setting - all four
lights flashing indicates zero cups
set.
2.
Press the Portion button again and
then repeatedly to continue incre-
menting the quantity. Note that
the Portion will increment from left
to right. Setting will automatically
save after 2 seconds of inactivity.
3.
The maximum dispensed per meal
is 1 cup (4 x 1/4 cups). You will see
the Quantity Indicator Lights (see
image above) between the Portion
and Meals buttons correspond to
how many 1/4-cup increments will
dispense per meal.
Note: All four Quantity Indicator Lights may
flash upon initial press of the Portion or Meals
buttons to indicate zero Portion or Meals set.
877. 250.7729 | feeder-robot.com
18
Meals
Quantity Indicator
Set Feeding Frequency
1.
Press the Meals button once to see
the current setting - all four lights
flashing indicates zero meals set.
2.
Press the Meals button again, and
then repeatedly to continue incre-
menting the quantity. Note that
the Meals will increment from right
to left. Setting will automatically
save after 2 seconds of inactivity.
3.
The maximum number of meals
dispensed per day is 4. You will
see the Quantity Indicator Lights
between the Portion and Meals
buttons correspond to how many
meals will dispense per day.
4.
After the number of meals has
been set, the first meal will be
immediately dispensed, and the
24-hour period (or day) begins
upon the first meal dispensed.
Note: The unit will start the feeding schedule immediately after both portion and meals are
initially entered, and the first meal will be dispensed.
Once a schedule is set from the Control Panel, you can adjust the portion without
affecting the timing of the scheduled meal. If the number of meals is changed,
then the scheduled timing will be restarted and the first programmed meal will
be dispensed immediately. Setting either Portion or Meals back to zero (all four
Quantity Indicator Lights blinking) will turn the schedule off.
Control Panel Lockout
Control Panel Lockout disables button functions to prevent unwanted
changes. The Feeder-Robot functions normally in Automatic Feeding
Mode during Control Panel Lockout.
●
Press and hold the Feed button for 3 seconds to enter or exit Control
Panel Lockout. The Status Indicator Light on the top of the unit will
flash white to confirm the status has changed.
●
While in Control Panel Lockout, you can turn the unit OFF by
pressing and holding the Power button for 3 seconds.
Night Mode
A 3-second press of the Gravity Mode button enables or disables Night
Mode. When Night Mode is enabled, all lights on the Control Panel and
Status Indicator Lights (top of unit) are automatically dimmed when
ambient light is low. The Ambient Light Sensor is located on the Control
Panel to the right of the Connect button (see page 12). Test Night Mode
by placing your hand or finger over the Ambient Light Sensor. All lights
should dim with your hand or finger covering the Ambient Light Sensor.
877. 250.7729 | feeder-robot.com
19