Dynasty DSCT -36-6 Інструкція з монтажу Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Варильна поверхня Dynasty DSCT -36-6. Dynasty DSCT -36-6 12 сторінок. Dynasty gas cooktop

Друкувати сторінку

operatior1

Shut off gas supply before removing an old cooktop

and leave it off until new installation is completed.

Use only pipe joint compound that is approved for

use with liquified petroleum gases. Install a manual

shut-off valve in an accessible location in the gas

piping, external to the range for the purpose of

turning on or shutting off gas to the cooktop.

.The appliance and its individual shut-off valve

must be disconnected from the gas supply piping

system during any pressure testing of that system

at test pressures in excess of 1/2 psig (3.5kPa)

.The appliance must be isolated from the gas supply

piping system by closing its individual manual

shut-off valve during any pressure testing of the

gas supply piping system at test pressures equal to

or less than 1/2 psig (3.5 kPa). Check incoming

gas supply pressure and the manifold pressure

(after the regulator) using a manometer. The

required manifold pressure for natural gas is 5"

water column and for LP is 10" W.C. The gas

supply line must be at least 1" W.C. (249 fa)

above the manifold pressure and must not exceed

14" W.C. (3.5 kPa or 1/2 psi)

Check for gas leaks using soap-water solution. DO NOT USE OPEN FLAME TO CHECK FOR LEAKS

3 FT ELECTRICAL CORD

WITH 3-PRONG ANGLED PLUG

120V/1-PH/60HZ/4AMPS

3/4 B.I. PIPE

(VERITICAL OR HORIZONTAL

CONNECTION)

RFAR VIEW

(SHOWN WITH OPTIONAL BACK GUARD)