Autopilot REVOLVE F20 Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Контролер Autopilot REVOLVE F20. Autopilot REVOLVE F20 12 сторінок. Repeat cycle and light combo timer

Друкувати сторінку

OPERATING INSTRUCTIONS

LIGHT ON/OFF SETTING

NOTE: The unit's clock uses 24-hour military time format and not a.m./p.m.

LIGHT ON TIME: Click the LIGHT ON TIME knob and turn to set your desired on time point, e.g. turn

light on at 06:00 (6:00 a.m.). Click the LIGHT ON TIME knob again to save the setting.

LIGHT OFF TIME: Set light off time the same way, using the LIGHT OFF TIME knob. Click the LIGHT

OFF TIME knob again to save the setting.

SET CLOCK: Press both knobs simultaneously and hold for 3 seconds to set the 24 hour time clock,

press both knobs to save the setting. After the clock has been set, the internal battery will maintain

the correct time even if there is an interruption of power.

RECYCLE TIMER SETTING

ON TIME: Click the ON TIME knob and turn to set. Set the hour setting first, then press again to set

minutes, and finally seconds. Save the setting by pressing again.

OFF TIME: Set off time by the same process, using the OFF TIME knob.

NOTE: The display will count down by second in the last minute.

TEST/OVERRIDE RECYCLE TIMER FUNCTION: This function can be used to quickly test the

programmed cycle timer setting, or override the programmed cycle times. To test the programmed

On Time cycle, press and hold the On Time knob for 3 seconds. To test the Off Time cycle, press and

hold the Off Time knob for 3 seconds.

MAXIMUM TEMPERATURE SETTING

Click the MAX TEMP knob to set max temperature. Click the TEMP UNIT knob to choose Fahrenheit

or Celsius.

HIGH TEMPERATURE SHUTOFF

This feature will shut off the supplemental lighting if the temperature in the growing area goes

above the user-set maximum temperature setting. This will protect plants from excessive heat in the

event of a ventilation failure or unusually high heat loads.

For example, if the max temperature set point is 90°F/32°C, in the event the grow room temperature

reaches this point, the light will be shut off. In the meantime, the top display (LIGHT) will count

down a 15-minute lamp re-fire interval, and the middle display (TEMP °C/°F) will flash the

temperature repeatedly. When the room temperature goes down to 88°F/31°C (2°F/1°C less than the

user-set max temp), and the 15-minute countdown has finished, the light will be re-fired.

The 15-minute lamp re-fire interval is adjustable from 3 to 15 minutes by pressing the LIGHT OFF

TIME knob for 3 seconds to enter the setting.

To cancel the countdown, press and hold the LIGHT ON TIME knob, and watch as the controller fast

forwards the re-fire countdown to zero.

RECYCLE OUTPUT

DAY mode: The outlet is only energized while the LIGHT ON mode is activated.

24 HOURS mode: The outlet is energized during day and night (during lights-on and lights-off). The

setting should be entered from day/night mode.

NIGHT mode: The outlet is energized only while the LIGHT OFF mode is activated.

NIGHT OUTPUT

This outlet is energized at all times when the LIGHT OFF mode is activated, and so any night device

plugged into it such as a dehumidifier or fan will be continuously active during the lights-off period.