High-Flying HF-LPT270-1 Посібник користувача - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник користувача для Блок управління High-Flying HF-LPT270-1. High-Flying HF-LPT270-1 19 сторінок. Wi-fi+ble module
Друкувати сторінку
HF-LPX70 SeriesWi-Fi&BLE User Manual
1.2.8. Hardware Typical Application
Figure 11. HF-LPT270 Hardware Typical Application
Notes:
nReset- Module hardware reset signal. Input. Logics "0" effective.
There is pull-up resister internal and no external pull-up required. When module power up or some
issue happened, MCU need assert nRST signal "0" at least 10ms, then set" 1" to keep module fully
reset.
nLink- Module WIFI connection status indication. Output.
(This pin is recommend to connect to LED, indicate status when the module in wireless
upgrade mode)
When module connects to AP (AP associated), this pin will output "0". This signal used to judge if
module already at WiFi connection status. Thers is pull-up resister internal and no external pull-up
required. IfnLink function not required, can leave this pin open.
nReady- Module boot up ready signal. Output. Logics "0" effective.
The module will output "0" after normal boot up. This signal used to judge if module finish boot up and
ready for application or working at normal mode. If nReady function not required, can leave this pin
open.
nReload- Module restore to factory default configuration.Input. Logics "0" effective.
(This pin is recommend to connect to button, is used to enter wireless upgrade mode)
User can de-assert nReload signal "0" more than 4s through button or MCU pin, then release, module
will restore to factory default configuration and re-start boot up process.. If nReload function not
required, can leave this pin open.
UART0_TXD/RXD- UART port data transmit and receive signal.
- 16 -
Shanghai High-Flying Electronics Technology Co., Ltd(www.hi-flying.com)