Autopot 48Pot XL Інструкції з налаштування - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкції з налаштування для Система зрошення Autopot 48Pot XL. Autopot 48Pot XL 2 сторінки.
Друкувати сторінку
48Pot XL system contents
• 1x 400 ltr FlexiTank
• 24x 16 - 6mm cross connector
• 48x 1Pot XL tray and lid
• 1x 16mm cross connector
• 48x 25 ltr pot
• 20 metres of 16mm pipe
• 48x AQUAvalve
• 24 metres of 6mm pipe
• 1x 16mm tank adapter and filter
• 48x XL root control disc
• 3x 16mm in-line tap
Suggested layout
400 ltr
FlexiTank
Elevate tank
150mm from
floor to maintain
gravity pressure
AQUAvalve
16mm click-fit tank adaptor & filter
6mm pipe
16mm pipe
• P ot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10 days
before turning your system on. This will encourage a stronger and healthier root system.
• A lways raise your tank to a minimum of 150mm above the highest AQUAvalve and re-fill the tank when
there is approximately a 1/3 of the solution left - NEVER ALLOW THE TANK TO RUN EMPTY.
• F or best results, we recommend mineral fertilisers. Do not use organic fertilisers, as they have a tendency to
block small pipe work.
• C lean all substrate from the bottom and sides of the pots before placing in each tray.
This will ensure your system is clean from the start.
• A lways use free draining substrates, for example: soil/perlite, coco/perlite, soil/clay pebbles,
coco/clay pebbles, rockwool/clay pebbles.
[email protected] I www.autopot.co.uk I +44 (0)844 8581520
Plan views
and options
System requires minimum
400 litre FlexiTank (supplied)
16mm – 6mm cross connector
16mm cross connector
16mm in-line tap
Advice
1Pot XL dimensions
330mm
380mm
25 ltr
pot
275mm
1
Place circular
root control disc
gold face down
in the pot.
3
Remove collar.
Push 6mm pipe through
collar
and
attach
AQUAvalve nozzle.
Rescrew collar - DON'T
overturn... when you feel
it grip STOP.
5
Position tray so it is
level.
7
According to the size of your system connect your
6mm/16mm pipe to relevant fitting or tank...
Using your front instruction sheet, repeat the module set up instructions for the number of trays.
Allow your plants to establish for 7-10 days before turning system on
Advice
If you require any guidance email - [email protected]
48Pot XL system
setup instructions
400 ltr
FlexiTank
680mm
2
Fill pot with medium
and pot up plants.
Water through pot
and allow to drain
outside the tray.
4
to
Connect AQUAvalve
so 'half moon' is on T
section in the tray.
6
Cut 6mm/16mm pipe
to appropriate length
8
Place
pot
tray, make sure it is
CLEAN!
Place lid over valve
onto tray.
in
the