Galileo Quark SoC X1000 Посібник для початківців - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник для початківців для Комп'ютерне обладнання Galileo Quark SoC X1000. Galileo Quark SoC X1000 20 сторінок.

Друкувати сторінку

Custom Arduino Sketch

If you don't have the weird 3.5mm RS-232 interface cables, never fear! You can upload an Arduino

sketch to access the Linux terminal.

One warning here: this sketch does mess with some of the basic workings of the Galileo. You won't

be able to upload another Arduino sketch unless you reset the board or run the few lines at the end

of this section.

Copy the code below into your Arduino IDE. Then upload just as you did the Blink sketch. This is a

slightly modified version of the code found in Intel's

language:c

void setup()

{

system("cp /etc/inittab /etc/inittab.bak"); // Back up inittab

// Replace all "S:2345" with "S0:2345"'s (switching serial ports):

system("sed -i 's/S:2345/S0:2345/g' /etc/inittab");

// Replace all "ttyS1" with "ttyGS0"'s (switching serial ports):

system("sed -i 's/ttyS1/ttyGS0/g' /etc/inittab");

// Replace all "grst" with "#grst"'s to comment that line out:

system("sed -i 's/grst/#grst/g' /etc/inittab");

// Replace all "clld" with "#clld"'s to comment that line out:

system("sed -i 's/clld/#clld/g' /etc/inittab");

system("kill -SIGHUP 1");

}

void loop()

{

}

Once that's uploaded, you'll need to open up a separate serial terminal program (not the Serial

Monitor). Set the serial port to the same as your Galileo, and set the baud rate to 115200. See the

below section

for help using Linux.

Once you're done using this version of the serial terminal, send this trio of commands to revert back

to "Arduino mode":

language:c

rm /sketch/sketch.elf

cp /etc/inittab.bak /etc/inittab

kill -SIGHUP 1

Those will remove your terminal "Arduino sketch", revert back to the old

the

process. Your Galileo will revert back to the way it was, and you can upload an Arduino

init

sketch once again.

Using the Linux Terminal

When you first open your Linux terminal, press enter. You'll the be prompted to log in, use the user

name root (no password, by default). Welcome to the shell!

example code

Page 16 of 20

samples.

procedure, and reboot

init