Autopot AQUAvalve 4Pot system Прості інструкції з догляду
Переглянути онлайн або завантажити pdf Прості інструкції з догляду для Газонна та садова техніка Autopot AQUAvalve 4Pot system. Autopot AQUAvalve 4Pot system 2 сторінки.
Друкувати сторінку
Ensure the yellow silicon is sitting parallel
on the hole below it. Hold at eye level
to check that the position is correct
Ensuring that the AQUAvalve floods
and drains correctly
Making sure your AQUAvalve floods and
1
drains correctly is simply achieved and
only takes a few seconds.
Hold the AQUAvalve at eye level so that
2
you can see the yellow silicon fitted to the
top float resting on the hole below it.
3
The yellow silicon must create a tight seal
when touching the hole.
If it looks like it is not sitting parallel on
4
the hole below simply lift the top float and
apply pressure to one side of the yellow
silicon, drop the float and hold at eye level
again. Repeat the procedure if necessary.
Simple care
guidelines
Care and maintenance
At the end of your growing season, clean
1
the AQUAvalve using warm soapy water.
Using an old tooth brush will help.
The AQUAvalve is easily disassembled.
The top float will slide all the way across
and the bottom float is unclipped from its
pivoting position. The circular discs fitted to
the top float can also be removed by using
pliers to grip the raised point.
At this point it is advisable to remove the
yellow silicones to avoid them being lost.
It is also handy to have a paper clip or pipe
2
cleaner so that you can push it through the
AQUAvalve nozzle. This will remove any
lime scale build up that may have occurred
during the growing season.
Blowing through the AQUAvalve nozzle will
also help to remove any build up. Do not
under any circumstances use a drill & drill
bit to clear the AQUAvalve nozzle.
This
will
potentially
damage
AQUAvalve beyond repair.
I
www.autopot-usa.com
Your 4Pot system
set-up guidelines
Layout 2
the
4
Layout 1
I
www.autopot-usa.com
Trays & Pots
available in
black