Galiso HDD-8RB Інструкція з монтажу/експлуатації - Сторінка 8

Переглянути онлайн або завантажити pdf Інструкція з монтажу/експлуатації для Сушарка Galiso HDD-8RB. Galiso HDD-8RB 14 сторінок. With digital control
Також для Galiso HDD-8RB: Інструкція з експлуатації (12 сторінок)

Друкувати сторінку

5.0 OPERATION

A. Check that Cylinders are emptied and drained of water.

B. Place a Probe into each Cylinder that is going to be dried, and align under each

individual Manifold Outlet. Connect each Probe by pushing up into a Quick

Connect on the Upper Body.

NOTE: Avoid bending or otherwise damaging the Probes.

C. When cylinders have been loaded, flip the Power Switch up, to the ON position.

D. The display on the PID Controller will read the last set temperature. For example,

see Figure 2, below. The temperature to achieve (Goal Temperature), shown

here is 250° F. Each time the HDD is powered up, the display will read the

temperature that was set to achieve when the machine was turned off.

E. The Current Running Temperature of Air Flow, as measured in the Main Body

Heat Tube. Shown here as 242°F. This will be an approximate of the temperature

of air flow through the Probes.

F. To change the desired temperature, simply press the Arrow Up

Down

Buttons. Increments will change by 1°F by pressing once. By pressing

and holding the Up or Down Buttons, increments will begin changing by 10° F.

21-11-1025

Figure 2, HDD Controller

or Arrow

Section 5 - 1