Gallagher C300401 Вказівки щодо встановлення - Сторінка 9
Переглянути онлайн або завантажити pdf Вказівки щодо встановлення для Зчитувач карток Gallagher C300401. Gallagher C300401 12 сторінок. Reader
Також для Gallagher C300401: Вказівки щодо встановлення (12 сторінок)
Друкувати сторінку
5.
Fit the facia assembly into the bezel by clipping the small lip, into the top of the bezel and holding
the top, press the bottom of the facia assembly down into the bezel.
6.
Insert the M3 Torx Post Security screw (using a T10 Torx Post Security screwdriver) through the
hole at the bottom of the bezel to secure the facia assembly.
Note: The Torx Post Security screw needs only to be lightly tightened.
7.
Removal of the facia assembly is a simple reversal of these steps.
8.
Configure the reader in Command Centre. If the reader is connected as an HBUS Reader, refer to
the topic "Configuring HBUS Devices" in the Command Centre Configuration Client Online Help.
If the reader is connected as a Cardax IV Reader, refer to the topic "Creating Readers" in the
Command Centre Configuration Client Online Help.
5
LED indications
LED (squiggle)
3 Flash (Amber)
2 Flash (Amber)
1 Flash (Amber)
On (Green or Red)
Flashes Green
Flashes Red
Flashes (Blue)
3E4288 Gallagher T10 Reader | Edition 1 | August 2016
Copyright © Gallagher Group Limited
Reader tail
Building cable
Facia
Fit screw to secure facia to bezel
HBUS indication
No communications with the Controller.
Communications with the Controller, but reader is not configured.
Configured to a Controller, but reader is not assigned to a door or elevator car.
Fully configured and functioning normally.
Green = Access mode is Free
Red
= Access mode is Secure
Access has been granted.
Access has been denied.
Reading and validating a PIV card.
Connection
Page 9