DynaTrap DT1260 Інструкція з монтажу
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Обладнання для боротьби з комахами DynaTrap DT1260. DynaTrap DT1260 3 сторінки.
Друкувати сторінку
PULL
1
LOWER
TUBE
Unpack the unit, and place it on the ground. Pull the cord tight through the
middle tube and connect to upper tube. Make sure connection clip is secure
before proceeding.
BASE
POLE
CONNECTOR
NUT
POST
BASE
TWIST
3
TIGHTEN
Insert base connector post through bottom of stand base. Align connector
post with notch in base and connect to pole. Rotate pole nut until secure.
ASSEMBLY INSTRUCTIONS
MIDDLE
TUBE
UPPER
TUBE
CONNECTION
CLIP
For Additional Information Visit www.DynaTrap.com
2
LOWER
TUBE
PULL
CONNECTION
CLIP
Pull the cord tight through the lower tube and connect to middle tube.
Make sure connection clip is secure before proceeding.
4
Place dynatrap in upright position and connect to electrical outlet
and turn power switch "on" to operate.
ENGLISH
MIDDLE
TUBE
UPPER
TUBE
GROUND
A000-316.2021.2