DCS EH-36SS Інструкція з використання та догляду - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з використання та догляду для Вентиляційна витяжка DCS EH-36SS. DCS EH-36SS 11 сторінок. The professional euro vent hood
Також для DCS EH-36SS: Посібник з використання та встановлення (18 сторінок), Інструкція з використання та догляду (7 сторінок), Посібник з монтажу (14 сторінок), Посібник з монтажу (16 сторінок)
Друкувати сторінку
SAFETY PRACTICES & PRECAUTIONS
This Euro Hood system is designed
to remove smoke, cooking
vapors and odors from the cooktop
area.
WARNING:
ALL WALL AND FLOOR OPENINGS WHERE THE EURO HOOD IS INSTALLED MUST
BE SEALED.
Consult the cooktop
or range installation
instructions
given by the manufacturer
before making any
cutouts.
MOBHLE HOME INSTALLATION- The installation
of this Euro Hood must conform
to the
Manufactured
Home Construction
and Safety Standards, Title 24 CFR, Part 3280 (formerly
Federal
Standard for Mobile Home Construction
and Safety, Title 24, HUD, Part 280). Three wire power suppHy
must be used and the appHhnce wiring
must be revised. See EHectrica[ Requirements
(see [nstaHHation
Manual, page 5.)
[] Venting system MUST terminate
outside the home.
[] DO NOT terminate
the ductwork
in an attic or other encHosed space.
[]
DO NOT use 4" [aundry-type
waN[caps.
[] FHexible-type ductwork
is not recommended.
[] DO NOT obstruct
the flow of combustion
and ventilation
air.
[] Failure to follow venting
requirements
may result in a fire.
[] Electrical ground is required on this Euro Hood.
[] If cold water pipe is interrupted
by plastic, non-metallic
gaskets or other materials, DO NOT use
for grounding.
[] DO NOTground
toa gas pipe,
[] DO NOT have a fuse in the neutral or grounding
circuit,
A fuse in the neutral or grounding
circuit could result in electrical
shock,
[] Check with a qualified
electrician
if you are in doubt as to whether
the Euro Hood is properly
grounded,
[] Failure to follow electrical
requirements
may result in a fire,
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
Use this unit only in the manner intended
by the manufacturer.
If you have
any questions,
contact
the manufacturer.
Before servicing
or cleaning
unit,
switch power off at service panel and lock the service disconnecting
means to
prevent power from being switched on accidentally.
When the service discon-
necting means cannot be locked, securely fasten a prominent
warning
device,
such as a tag, to the service pane[. Installation
Work And Hectrica[ Wiring Must
Be Done By Qualified
Person(s) In Accordance
With A[[ Applicable
Codes And
Standards,
Including
Fire-Rated
Construction.
Sufficient
air is needed
for
proper combustion
and exhausting
of gases through
the flue (chimney) of fuel
burning
equipment
to prevent backdrafting.
Follow the heating equipment
manufacturer's
guideline
and safety standards such as those published
by the
National
Fire Protection
Association
(NFPA), and the American
Society for
Heating, Refrigeration
and Air Conditioning
Engineers (ASHRAE), and the local
code authorities.
When cutting
or drilling
into wall or ceiling, do not damage
electrical
wiring and other hidden utilities.
NOTE: Ducted fans must always be vented to the outdoors.
3