DCS EH-36SS Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з монтажу для Вентиляційна витяжка DCS EH-36SS. DCS EH-36SS 14 сторінок. The professional euro vent hood
Також для DCS EH-36SS: Посібник з використання та встановлення (18 сторінок), Інструкція з використання та догляду (11 сторінок), Інструкція з використання та догляду (7 сторінок), Посібник з монтажу (16 сторінок)

INSTALLATION INSTRUCTIONS

5) Determine and make all necessary cuts in the wall for the ductwork. Each Euro Hood is shipped

from the factory vented through the top. In order to vent to the rear, ductwork must run first

vertical then elbow to the back. The dimensions for the duct openings are given in Fig. 02a and

Fig. 02b. Install all ductwork before installing the Euro Hood.

6) Determine the proper location for the power supply cable as indicated in Fig. 02a & 02b. DO

NOT turn on the power until installation is complete.

INSTALLING THE EURO HOOD

1) Remove the unit from the carton and place on a

flat surface for assembly. Cover the surface to

prevent accidental damage. Remove all parts

including the mounting hardware before

discarding the carton.

2) To remove filter:

Pull knob forward (towards you) and turn to the

left at same time.

3) Remove the cover from the field wiring

compartment. Remove the wiring electrical

knockout using a flat-blade screwdriver. Feed

the power supply cable through the electrical

knockout.

4) The canopy attaches to the wall by two screws discussed earlier in the installation instructions.

The canopy hangs from these screws by brackets inside the Euro Hood shown in Fig. 10. Before

attempting to hang the canopy, you should rotate the adjustment screw marked V1 in Fig. 10

counter clockwise to extend the brackets from the canopy. Using a Phillips head screwdriver,

rotate this screw counter clockwise to extend the bracket.

5) Install the damper before hanging the Euro Hood. The damper attaches to the Euro Hood by

two small screws provided in the hardware package.

6) Hang the Euro Hood canopy from the screws. Due to the weight of the canopy, these screws

must be installed into solid material! Once the canopy is hung, rotate the screw marked V1 to

secure the Euro Hood to the wall.

NOTE: Make sure that the Euro Hood is securely attached to the wall! Failure to properly install

could result in injury or damage to property.

7) The brackets shown in Fig. 10 are also used to adjust the level of the canopy. Using a Phillips

screwdriver, rotate the screw V2 to adjust the level of the canopy.

8) Connect the Power Supply Cable to the Euro Hood. Attach the White lead of the power supply

to the White lead of the Euro Hood with a twist-on type wire connector. Attach the Black lead

of the power supply to the Black lead of the Euro Hood with a twist-on type wire connector.

Connect the Green ( Green and Yellow ) ground wire under the Green grounding screw.

9) Replace the field wiring compartment cover and the grease filters.

To install grease filter: Put the end of grease filter without the knob into the channel in the

front of hood. Turn knob to the left so the lever does not protrude from filter. Insert knob end

of grease filter into the channel in the back of the hood. Turn knob to the right, locking filter in

place.

DAMPER

FIG.10