DCS Vent Hood ES36 Посібник з монтажу - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник з монтажу для Вентиляційна витяжка DCS Vent Hood ES36. DCS Vent Hood ES36 20 сторінок. The professional and euro vent hood
Також для DCS Vent Hood ES36: Інструкція з використання та догляду (13 сторінок)

Друкувати сторінку

1. Parts

BEFORE INSTALLING HOOD

ELELCTRICAL

Install a 1/2" conduit from the service panel long enough to reach the hood once it is installed.

Branch circuit requirement is 120V, 60Hz, 15A(minimum).

INFRARED LAMP AND PANEL KIT

Optional infrared lamp and panel kit can be ordered separately and mounted into your vent hood.

Models available: IR30, IR36 and IR48. See instructions supplied with kit for assembly to your hood.

WARNING

To avoid any electrical shock the installation of the IR lamp should be done

by a qualified electrician and before starting the installation of the hood.

DUCTING

Hood models: ES30, ES36, VS30, VS36 are supplied with a starting collar and backdraft damper on top

of the hood for connection to 8" round duct. Models: VS1236 and VS48 are supplied with a 10" round

transition with damper and is assembled as shown in Fig. 3.

Vertical Discharge Figure

Horizontal Discharge Figure

Install ducting long enough to reach the transition once the hood is installed plus 1-1/2 inch to

connect ductwork.

ASSEMBLE TRANSITION TO HOOD (VS1236 and VS48 hoods only)

The transition supplied with the hood mounts to the top of the

hood, Figure 3.

1. Place the transition piece over the hood exhaust and

secure with 4 screws provided (Figure 3).

2. Duct tape connection between transition and hood.

3. Remove tape holding damper

canopy

FIG. 1

canopy

FIG. 2

FOR 90

ELBOW

10"

FIG. 3

16"

11"