Highlite International Showtec LED Powerbar 24 Посібник з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Освітлювальне обладнання Highlite International Showtec LED Powerbar 24. Highlite International Showtec LED Powerbar 24 13 сторінок.

Друкувати сторінку

Installation

Remove all packing materials from the

removed. Connect all cables.

Do not supply power before the whole system is set up and connected properly.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

3-pin waterproof cable

Connection

Connect the input connector of the first fixture to the output connector of the DMX console; connect the

output connector of first fixture to the input connector of the second fixture; etc., as shown in following

diagram.

1) Put the output connector of the first fixture into a Φ20 thermal shrinking sleeve with glue inside. The end of

the sleeve should be 5mm from the joint of the cable and the connector.

2) Put the input connector of the second fixture into the Φ20 thermal shrinking sleeve so as to connect it with

the output connector of the first fixture.

3) Blow and shrink the sleeve ends with a hair drier so that the sleeve and the signal cable are tightly

contacted for waterproof purpose.

The signal output connector of the last fixture (maximum 30 fixtures) of each series must be sealed with aΦ20

thermal shrinking sleeve and blow and shrink it with a hair drier for waterproof purpose.

LED Powerbar

24. Check that all foam and plastic padding is

special 3-pin to XLR cable

大功率单行旋转投光灯电气连接图

Fig. 3