Dynaudio 9S Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Сабвуфер Dynaudio 9S. Dynaudio 9S 18 сторінок. Precision bass, optimised for the studio
Друкувати сторінку
Controls and connections
1.
POWER ON (Main)
6.
Lowpass
Main power switch (to switch the
Subwoofer lowpass frequency:
subwoofer manually on and off). LED
continuously variable from 50 to
shows operation mode:
150Hz.
• red: subwoofer switched on and in
mute mode
7.
SAT/SUB (output)
• green: subwoofer is activated
Output for satellite system to be
connected. This signal is processed
2.
AC IN
according to the Highpass setting.
Mains power input.
8.
Highpass
3.
Power (Mode)
Allows cutting off low frequencies
• On: subwoofer is permanently on
of the signal provided at the T/SUB
• Auto: subwoofer switches on
output:
when signal is detected
• Flat: signal is not processed
• 60: cutoff frequency at 60Hz
4.
Gain
• 80: cutoff frequency at 80Hz
Subwoofer volume level.
9.
SAT/SUB (input)
5.
Phase
Input for full bandwidth signal. This
Phase setting: phase can be s et to
signal will be processed according to
0° or 180°.
the Highpass setting and provided at
the SAT/SUB output.
12
10.
LFE
• LFE/Slave: input for LFE signal
• Slave: output to next subwoofer if
installed
11.
Mode
Subwoofer operation mode LFE or
Slave:
• LFE: setting for normal use and
Master use
• Slave: setting for second and all
following subwoofers
Terminal pinout (sockets 9, 10 and 11)
1 = 0
2 = +
3 = –
4.
3.
POWER
GAIN
PHASE
ON
AUTO
0° 180°
Min
Max
SAT Highpass
SUB Lowpass
Flat
60Hz
80Hz
8.
50Hz
150Hz
SAT/SUB Input
SAT Output
LEFT
9.
RIGHT
LFE / Slave IN
OUT
10.
SUB I/O
To Slave
11.
LFE
Slave
~ 50/60Hz 3.15A
ON
1.
OFF
FUSE T3.15A L 250V
Before operation
5.
6.
7.
2.
13