HighPoint SSD7000 Series Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з монтажу для Комп'ютерне обладнання HighPoint SSD7000 Series. HighPoint SSD7000 Series 14 сторінок. Linux rocky linux
Також для HighPoint SSD7000 Series: Посібник з монтажу (16 сторінок), Посібник з монтажу (12 сторінок)
Друкувати сторінку
Linux Rocky Linux on SSD7540/7505/7502/7202/7105 Installation Guide
1 Overview
The purpose of this document is to provide clear instructions on how to install Linux
Rocky Linux on the SSD7000 controller.
Supported system: Rocky Linux 8.6/8.7/9.0/9.1
Supported controller: SSD7540/7505/7502/7202/7105
2 Installing Linux Rocky Linux on SSD7000
controller
If you would like to install Linux Rocky Linux onto drives attached to SSD7000 controller,
please perform the following operations:
Step 1 Prepare Your Hardware for Installation
After you attach your NVMe SSD to SSD7000 controller, you can use SSD7000 EFI
Utility to configure your NVMe SSD as RAID arrays, or just use them as single disks.
Before installation, you must remove all the NVMe SSD, which are not physically attached
to SSD7000 controller, from your system.
Note
SSD7000 only support EFI boot. If you have other SCSI adapters installed, you must
make sure the SSD7000 controller EFI will be loaded firstly. If not, try to move it to
another PCI slot. Otherwise you may be unable to boot up your system.
Step 2 Check System EFI Settings
In your system EFI SETUP menu, change Boot Sequence in such a way that the system
will first boot from EFI CDROM or EFI a Bootable USB drive, after you finish
installation, set SSD7000 RAID controller as the first boot device to boot up the system.
Refer to your motherboard EFI manual to see how to set boot sequence.
1. Set UEFI setting with SuperMicro X11DPi-NT motherboard as an example.
a.
"Advanced->PCIe/PCI/PnP Configuration->CPUSlot PCI-E OPROM"
to "EFI". Suppose SSD7000 is connected to motherboard CPU1 Slot 2 PCI-E X16,
then you should set "CPU1 Slot 2 PCI-E X16 OPROM" to "EFI";
- 1 -