HighPoint RocketRAID eSATA 3G HBASeries Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з монтажу для Контролер HighPoint RocketRAID eSATA 3G HBASeries. HighPoint RocketRAID eSATA 3G HBASeries 13 сторінок. Bootable raid
Також для HighPoint RocketRAID eSATA 3G HBASeries: Посібник з монтажу (10 сторінок)
Друкувати сторінкуNote: A 32 or 64‐bit EFI rom image is needed on the RocketRAID eSATA 6G series
controller to support booting to Mac OS X. Refer to the above table load the correct
EFI rom image to support your Mac Pro system.
Tip: The 32 or 64‐bit EFI rom image is found in the CD of the RocketRAID eSATA 6G
series controller and it is also available for download on the
http://www.hptmac.com website.
Before, installing the RocketRAID eSATA 6G series controller make sure the
computer is turned off and unplugged from its power source. Take appropriate
electrostatic discharge precautions:
Your computer is a static‐sensitive device. It is susceptible to invisible damage if not
protected during installation.
We recommend proper grounding by using a grounding strap. Make sure to work in
a clean and static‐free area, and avoid wearing clothing that retains static charges.
Part 3 Hardware Installation and Verification
Before installing the RocketRAID eSATA 6G series controller
• Make sure computer is turned off and unplugged from its power source
• Take appropriate electrostatic discharge precautions:.
Remove the PCIe slot cover.
Gently insert the RocketRAID eSATA 6G series controller into the PCIe slot and
secure the bracket to the computer chassis according to your chassis specifications.
After installing the RocketRAID eSATA 6G series controller, restart your computer.
After your computer has started, insert the Driver & Software Installation Disc to
install the necessary drivers for your computer's operating system.
Hardware Verification
Verifying the RocketRAID eSATA 6G series controller is installed into the Mac Pro
system:
Step 1: Click on About this Mac