DD-EFI Pro Expansion Module Посібник із швидкого старту - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Автомобільні аксесуари DD-EFI Pro Expansion Module. DD-EFI Pro Expansion Module 5 сторінок.
Друкувати сторінку•
(2) PWM Outputs:
o Configurable for either ON/OFF
o PWM Setup: Extended Control -> PWM Output 1 or 2
o Outputs are low side (Pull to Ground)
o Each capable of up to 6A
•
(7) Digital Inputs:
o Configurable for 12V or GND trigger with internal jumper
o Default internal jumper set to 12V
o Removal of the back cover to access jumpers
•
Digital Inputs 1, 2 & 3 - pre-configured in DD-EFI Dashboards for
o Provided T-Tap Wire Connector(s) for easy connection
o Left Turn Signal - Digital Input 1
o Right Turn Signal - Digital Input 2
o High Beam – Digital Input 3
•
Push Button Start
o Setup: Extended Control -> Push Button Start
o Input Port
▪
Select one of the available Digital Inputs
▪
This typically comes from the output of the push start button;
the inputs are preconfigured for 12v input.
o Output Port
▪
Select one of the available PWM Outputs
▪
These outputs provide a ground signal and are typically wired to
a relay that will provide the 12v to the starter solenoid.
•
Examples of other Digital Inputs uses:
o Factory Indicators – High Beam, Low Level Indicators, etc.
o AC Idle Up
o Launch Control
Digital Connector
4 | P a g e