adeptus 78101 Інструкція з монтажу Посібник з монтажу - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Висувна шухляда для LCD-дисплея adeptus 78101. adeptus 78101 12 сторінок. Cottage single drawer end table / nightstand
Друкувати сторінку
7
ATTACH THE TOP
• Attach the top of the unit (part 01) by first aligning the 4 dowels
(part A) that you installed in the side panels (parts 02 & 03) in
step 1 with the pre-drilled dowel holes in the top (part 01).
• Once aligned, push the the top (part 01) to the partially
assembled unit until flush.
• Secure the top (part 01) to the unit using 4 part B screws on
each corner as shown.
• Part B screws should just be tight. Do not try to force or over-
tighten screws as this could cause damage to parts.
B=04
4 x 30
mm
Screw
NOTE: It is easier to secure the top (part 01)
with the screws (part B) with the the unit
turned over (upside down) and on a hard,
clean surface.
8
ATTACH THE
BACK PANEL
Use all back panel
nails (part K)
evenly spaced.
!
They make the
unit strong.
Before attaching the back
panel, make sure the unit is
assembled squarely. Use an
27 mm
"L" Square tool, if necessary,
K=11
Back Panel
Nail
NOTICE:
• First make sure the unit is assembled squarely. Use an "L" Square tool, if necessary.
• Once the unit is square, you must determine the square installation of the back
panel. Use an "L" Square tool, if necessary.
• Once you have positioned the back panel (part 08) squarely, secure it to the unit
using 11 of part K nails evenly spaced, as shown.
• It is very important that you utilize all 11 nails. It strengthens the unit.
27 mm
as shown.
CONTAINED
TOP
01
A
B
A
03
K
K
K
K
08
K
K
K
K
K
K
K
A
A
B
B
B
02
8-11