CopperSmith CSPI-6012 Інструкція з монтажу Посібник з монтажу - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Промислове обладнання CopperSmith CSPI-6012. CopperSmith CSPI-6012 13 сторінок.

Друкувати сторінку

PART 2

Securing the Liner

TILE BACKSPLASHES

IMPORTANT: Liners installed immediately above the top edge of tile backsplashes thicker than

installed slightly forward — not flush with the back wall. The back filter bracket of the liner is 1" deep and tile

installations thicker than this will prevent the filters from being removable.

MOUNTING HOLES

NOTE: DRILLING THROUGH STAINLESS STEEL REQUIRES A TITANIUM BIT. BE CAREFUL NOT TO DRILL

THROUGH FILTER BRACKETS, ELECTRICAL COMPONENTS OR UL LABEL.

Because the CopperSmith

drilled. This allows the liner to be attached in most any area of the canopy that has a wood frame support, e.g., the

back, sides or top. We recommend at least six equally spaced screws per liner— three screws along the back (top

or back side panel) and three screws on the front top, immediately next to the light bar (instead of the sides or

back). This will help prevent distorting the liner walls in situations where the wood frame is wall or behind the

removable light bar. Where possible, the screw holes should be drilled into the top of the liner not properly sized to

the liner. Models with internal motors should also have at least one screw centered and securely in place

on each end (side panel) of the liner because of the added weight.

Neatly measure and mark (left to right and top to bottom) and drill screw holes through the liner as required to

match the wood backing. It is easier to drill holes from the outside in, by setting the liner on its face (on cardboard)

and drilling from the back side. Secure the liner by driving screws (by others) tightly into the wood frame. Use

washers where necessary. When removing the filters, be careful not to scratch the liner by placing the filters,

screws, drill bits or drill on the liner's face.

CONNECTING TO THE VENT PIPE

The liner comes with a metal start collar welded in place. Attach the start collar to the duct with at least three

equally spaced screws. Also apply duct tape, preferably the metal type. Some installations (where the outside of

this portion of the duct is not accessible) will require the metal tape be applied on the inside of the duct. For better

access to these installations, the center bracket on the 42" liner model is removable. Be careful not to scratch the

liner when removing/reinstalling the bracket.

PART 3

Use and Care

WARNING!

Do NOT operate the blower / ventilator system without the filters in place, or with dirty, grease laden filters.

OPERATING CONTROLS:

Always activate the ventilator when using cooking appliances. For best performance, turn on the blower a few

minutes before starting to cook to establish an airflow pattern within the room. Adjust the fan speed by turning the

knob. To turn off blower, turn knob to off position. For controlling the lighting, turn the other knob.

If the model has electronic touch control, touch the button that corresponds to the desired speed. To turn off

blower, touch the illuminated speed button again.

off.

Revised 05/15/20

Liner was designed for various hood applications, no mounting holes have been pre-

The light control when touched comes on; touch again for light

" should be