Gallien-Krueger Legacy Series Посібник користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Gallien-Krueger Legacy Series. Gallien-Krueger Legacy Series 10 сторінок. Combo
Також для Gallien-Krueger Legacy Series: Посібник користувача (10 сторінок)
Друкувати сторінку
Quick Start:
These directions will take
you through the basics and give you a good
start for setting up your sound.
Connect your speakers: Connect your
speaker cabinets to the amplifier outputs
marked SPEAKER using a standard two
conductor speakon cable or Gallien-Krueger
four conductor speaker cable. Using the
Cabinet Impedance Switch, select the
speaker load that matches the total
impedance of the attached speaker cabinets
as outlined below.
Recommended speaker loads:
500W and 800W models:
(2 ohm total minimum load )
One 4 ohm cabinet
One 8 ohm cabinet
One 4 and one 8 ohm cabinet in parallel
( 2.7 ohms )
Two 8 ohm cabinets in parallel ( 4 ohms )
Two 4 ohm cabinets in parallel ( 2 ohms )
1200 watt models:
( 4 ohm min. load per output )
One 4 ohm cabinet
One 8 ohm cabinet
One 4 and one 8 ohm cabinet
( one cab per output )
Two 8 ohm cabinets
Two 4 ohm cabinets ( one cab per output )
*Higher ohm loads and no load are
acceptable for all 500, 800 and 1200 watt
models
Initial front panel control settings: Trim
knob to the full clockwise position. Drive,
Level and Master to full counter clockwise
position. All EQ and Edge controls to the 12
o'clock
position.
Contour, Presence and Mute switches to the
down position.
Connect your Instrument: Using a
shielded ¼" instrument cable, connect your
bass to the Input Jack and press the Power
Switch to the on (up) position. If you have
active tone controls on your bass, turn all of
the controls to the middle or "flat" position
LEGACY SERIES
Overdrive,
Bump,
and turn the volume all the way up. If you
have conventional, passive tone controls,
turn all tone and volume controls all the way
up.
Level and Master Volume settings:
Place the Mute in the up position.
Turn the Master up as you play until the
desired volume is reached. If distortion is
audible or the Clip Indicator flashes red
more than occasionally, turn the Trim
counter clockwise until there is no distortion
and the clip indicator activates occasionally
as the instrument is played aggressively.
You can now experiment with the EQ,
Bump, Contour, and Presence settings.
Drive Settings:
Place the Overdrive switch to the up
position. Turn the Drive to the 12 o'clock
position. Turn the Level up as you play to
the
desired
volume.
experiment with various Drive and Edge
settings. *As Drive is adjusted it may be
necessary to adjust the Level knob
to maintain consistent volume level.
8
You
can
now