Gallien-Krueger MB2 500 Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Gallien-Krueger MB2 500. Gallien-Krueger MB2 500 13 сторінок. Mb2 series
Друкувати сторінку
Sound Tips
The MB² Series has several unique features which, if
used properly, will obtain the sound you have been
searching for.
The Equalizer:
The Equalizer is used to fine tune your sound. When
adjusting making adjustments, do it just a little at a
time. These are active circuits and small changes can
make a big difference in your sound. With a little
experimentation you will find that this equalizer is
very easy to use and provides you with a large vari-
ety of great sounds unique to GK.
Contour:
Increasing the Contour level will scoop out mid-
range frequencies while boosting the highs and lows.
The sound, once again, is unique to GK and avail-
able on any other Bass amp. Lower contour settings
are recommended for midrange clarity at higher
playing levels.
Boost/Master B:
Turning up the Boost control will add a little growl
to your tone by adding a small amount of ever order
harmonic distortion. This is an unmistakable GK
trade mark sound that you will surely grow to appre-
ciate. Raising the Boost while lowering Master B
will add more growl while keeping the sound level
the same. You can use Master B to increase or lower
the overall output volume when switching the Boost
on via the front panel or from the included foot
switch. In either normal or boost mode, the cleanest
sound is obtained with Master Volume settings at 3
o'clock.
MB² SERIE S
Direct Out:
The MB² Series provides a low noise, high quality
balanced direct output for connection to PA and
recording consoles. A Ground Lift switch is
included to remove hum and buzz when connecting
to equipment powered by a different ground system.
With the Pre/Post EQ switch set to "Pre" (Out), the
direct output signal is fed directly from the input
stage providing a low noise output superior to exter-
nal direct boxes and impedance transformers. In the
"Pre" position, the direct output signal is only
effected by the Input Volume, -10db Pad and Mute.
This allows you to adjust your tone and volume on
stage without changing the Direct Output signal
level and confusing your sound man.
Changing the Pre/Post EQ switch to "Post" ( In),
sends the "GK Sound" (EQ settings etc.) and
preamp response to the Direct Out jack. This gives
you complete control over the Direct Out's tone and
volume.
9