Coralife Super Skimmers Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Лабораторне обладнання Coralife Super Skimmers. Coralife Super Skimmers 9 сторінок.
Друкувати сторінку
MAINTENANCE
MAINTENANCE
SAFETY: Always disconnect needle-wheel pump from power
supply before removing collection cup or cleaning unit.
WARNING: Only clean with warm fresh water. Do not use any
type of chemical cleaning agent to clean the skimmer. These
include, but not limited to, soap, detergents, alcohol, glass
cleaners, polishers, ammonia, etc.
1. To operate effi ciently, the Super Skimmer must be in use 24
hours a day.
DAILY MAINTENANCE
1. Make sure all connections are secure.
2. Observe to see if skimmer is functioning properly and producing
waste material.
NOTE: Skimmer may need to be adjusted accordingly due
to variables in water quality and fl uctuations.
3. Check to see if the collection cup is full and empty waste
material.
4. Check water outlet vent hole to make sure it is clear of dirt
and debris.
5. Check air-inlet silencer and make sure it is clean and free of dirt
and debris.
WEEKLY MAINTENANCE
1. Clean the collection cup and neck of organic build up.
2. Clean or replace the sponge and fi lter from the bubble
production diffuser.
MONTHLY MAINTENANCE
1. Clean water pump.
NOTE: Make sure to follow manufacturer instructions for
component's proper installation, operation and maintenance.
TROUBLESHOOTING
NOTE: Variables that affect skimming to produce dry
or wet foam are:
a. New Fish or Invertebrates
b. Frequent Feeding
c. Change in Water Chemistry
d. Supplements and Medication
e. Water Quality
f. Water Fluctuations/Evaporation
g. Addition of "Make-up" Water
h. Water Changes
i. Maintenance
j. Inserting hands in the tank
1. No microbubbles produced inside the skimmer.
a. The air-inlet silencer is clogged.
b. Pump is not plugged in.
2. No foam produced inside collection cup.
a. Adjust water level inside the skimmer.
b. New skimmer may take up to 72 hrs. to adjust properly
to aquarium system.
3. Water pump is not working.
a. Check to make sure power is supplied.
NOTE: Make sure to follow manufacturer instructions for
component's proper installation, operation and maintenance.
4. Skimmer water level fl uctuates (pulses).
a. The output tubing air vent hole is clogged causing the
skimmer to create a siphon.
b. Output tubing is too deep inside of bubble trap. Cut output
tubing and allow a 1" space inside the sponge (black).
5. Water is rapidly overfl owing into collection cup.
a. Reduce water level in the skimmer. Water level may be too
high.
b. Make sure water is fl owing through output tubing. Bubble
production diffuser may be clogged, blocking water fl ow.
c. Changes in water chemistry. Readjust water-level adjustment
dial to lower water level in skimmer.
d. Output tubing is pushed against white fi lter pad in bubble-
production diffuser. Allow 1" of space between bottom of
output tubing and fi lter pad (white).