AGS Parksafe Control Panel Експлуатація та технічне обслуговування установки - Сторінка 6

Переглянути онлайн або завантажити pdf Експлуатація та технічне обслуговування установки для Контролер AGS Parksafe Control Panel. AGS Parksafe Control Panel 16 сторінок. Ventilation control panel
Також для AGS Parksafe Control Panel: Посібник з монтажу та експлуатації (16 сторінок), Посібник з монтажу та експлуатації (16 сторінок), Посібник з монтажу, експлуатації та технічного обслуговування (20 сторінок)

Installation, Operation & Maintenance

Main Board Connections

POWER/ LINE IN.

110-120Vac mains power should be supplied to the [POWER/LINE IN] connector using a 3 core cable and fused at

3A. When mains power supplied to the panel - a red LED will illuminate located on the front cover.

OUTPUT 1 RELAY.

This relay output switches when any external gas detectors reach 'pre-alarm' status and the [0-10V OUTPUT] will

send 5V to ventilation systems.

OUTPUT 2 RELAY.

This relay output switches when any external gas detectors reach 'alarm delay' status and the [0-10V OUTPUT] will

send 10V to ventilation systems.

ALARM RELAY.

This relay output switches when any external gas detectors reach 'alarm delay' status for longer than the selectable

5 - 25 minutes time following the [OUTPUT 2] relay.

DAMPER RELAY.

This relay output can switch together with either OUTPUT 1, OUTPUT 2 or ALARM relays - selectable in the settings

menu.

DETECTOR CHAIN.

24vdc power and Modbus data is wired to Parksafe gas detectors [DETECTOR CHAIN] - [+ / - / D+ / D-].

Up to 16 detectors can be connected, chained in parallel up to approx. 500 yards from the panel depending on chain

configuration, wire type for power and condition. Connect detectors in a parallel (daisy chain) method.

Any other way may cause communication issues or damage to the overall system.

For MODBUS communications, a shielded and twisted pair cable is used. The shielding can be of 2 types: braided

[mesh of thin conducting wires] or foil (consisting of a thin sheet of metal covering the twisted wires).

If you are encountering noise or irregular problems with a Modbus link, the problem is likely related to grounding,

incorrect shielding or wiring mains power next to Modbus wiring.

For more information, refer to your Parksafe detector manual.

SOUNDER/ STROBE.

This relay output (24VDC) is for an external sounder alarms/ strobe lighting to activate on alarm.

24VDC

This is a permanent 24Vdc power output for external auxiliary devices. Max output: 200mA.

0-10V OUTPUT.

This output can drive ventilation systems. Under normal operating conditions, this output can send either 0 or 2V –

selectable in the settings menu. The [0-10V OUTPUT] will send 5V when [OUTPUT 1] relay is activated and 10V

when [OUTPUT 2] relay is activated.

Rev: 13

0721

Parksafe Control Panel