Coralife TurboTwist Series Інструкція з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Лабораторне обладнання Coralife TurboTwist Series. Coralife TurboTwist Series 12 сторінок. Uv sterilizer
Також для Coralife TurboTwist Series: Інструкція з експлуатації (6 сторінок)
Друкувати сторінку
Please read instructions in their entirety
Cut off the power and stop using
if the UV Sterilizer was submersed
or dampened by water.
Cut off the power if there is a
burning or smoking smell.
Never look directly at the
unshielded lamp or allow
prolonged exposure to skin as
the ultraviolet radiation emitted
from the lamp can be harmful.
Always leave a drip loop in the
power cord to prevent water from
running down the length
of the cord and
reaching the
power outlet.
The water temperature flowing
through the UV Sterilizer should
be below 105
o
F (40
o
C).
Always disconnect the UV Sterilizer
from the power supply before
shutting down the flow of water
to prevent overheating.
W A R N I N G
before using the UV Sterilizer.
Cut off the power immediately
if water enters into the quartz
housing.
Never connect the sterilizer to the
power outlet while hands are wet.
Do not pull cord to disconnect
power supply.
Though the Turbo-Twist is water
resistant, it should never be
intentionally submersed in water.
Always install the sterilizer in a
location where there is little likelihood
of flooding or water dripping onto the
UV Sterilizer.
Make sure that appropriately-sized
hose lock nuts are positioned on
hose barbs before attempting to
connect tubing.
Only a 120V (60 Hz) electrical
source should be used with the
Turbo-Twist.
8