Main Access 200200 Easy Incline Інструкція з монтажу

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Басейн Main Access 200200 Easy Incline. Main Access 200200 Easy Incline 1 сторінка. In-pool ladder

Main Access 200200 Easy Incline Інструкція з монтажу
Ladder Components
A) In-Pool Ladder Body
B) Handrails
C) Deck Flange
Hardware Kit
D) #10 x 3/4" Tek Screw
E) #10 x 1" Panhead Screw
Tools Required: Phillips and standard
screwdriver or bit, drill, 1-1/2" hole saw, pencil.
Note: Handrails should be mounted through the
deck boards for proper installation.
Note: Before you begin the assembly of your
ladder/step, please insure you have all components
and hardware.
Note: Contact our customer service department to
request any missing or damaged parts, hardware or
labels at 888-333-1134.
SAFETY INSTRUCTIONS:
• Install ladder per manufacturer's instructions.
• Locate IN-POOL LADDER on solid base.
• Ladder is designed for use by one person at a time.
• This ladder is intended for use as a swimming pool ladder only.
• Face ladder when entering and exiting the pool.
• No jumping, no diving from ladder.
• Do not swim through, behind or around the ladder.
Step 1 Handrail Assembly
Secure aluminum handrails (B) to the ladder body (A), the
shorter end of the handrail at the ladder body and the longer
end through the deck.
NOTE: Be sure to fully insert the handrail
into the ladder socket and secure with one
set screw #10 x 3/4" Tek Screw (D). Screw
should be secured through outside of each
ladder socket into the handrail to act as
a set screw to secure the handrail to the
ladder body.
Step 2 Ladder Position
Locate the final desired position of the in-pool ladder. Insure
the ladder bottom will rest flat and level on the bottom of
the pool. Position the handrails on the deck and mark their
final desired position with a pencil and set them aside. Using
the 1-1/2" hole saw, drill two holes through the deck boards
that will now support the in-pool ladder.
For models #200200 Easy Incline and #200300 Pro Series
Qty
1
2
2
Qty
4
6
S T E P B Y S T E P A S S E M B LY I N S T R U C T I O N S
IN-POOL LADDER
ASSEMBLY INSTRUCTIONS
B
D
D
A
Step 3 Secure Handrails to Deck
Place the deck flanges (C) around each handrail on the deck
side and insert the handrails through the holes in the deck
until the ladder rests flat and level on the bottom of the pool.
Secure each deck flange to the deck with three (3) #10 x 1"
Panhead Screws (E). Also secure the
handrail to each deck flange by once again
using one (1) #10 x 3/4" Tek Screw (D)
to act as a set screw to secure the handrail
into the final desired position.
NOTE: Up to four standard patio pavers or bricks can be
inserted in the bottom tread for additional ballast. Be sure to
shim the pavers or bricks firmly in place.
1004 Jaycox Road • Avon, Ohio 44011
888-333-1134
E
C
C
D
D